Loading ...
Loading ...
Loading ...
INSTALLATION
INSTRUCTIONS
Check that you have everything necessary for correct installation.
Proper installation is your responsibility.
8 or 10 in. pipe wrench
8 or 10 in. adjustable
wrench (for gas
connections)
Flat-blade screwdriver •
Adjustable wrench that •
opens to 1 in. or hex-
head socket wrench (for
adjusting dryer feet)
Level •
_/_in. nut driver or socket •
wrench
• Knife
• Safety glasses
• Vent clamps
Pipe-joint compound
resistant to L.R gas
Caulking gun and
compound (for installing
new exhaust vent)
Gloves
Pliers
Parts supplied:
Remove parts package from dryer drum. Check that all parts
were included.
4 leveling legs
Parts needed:
Check local codes and with gas supplier, check existing gas
supply, electrical supply and venting, and read "Electrical
Requirements," "Gas Supply Requirements" and "Venting
Requirements" before purchasing parts.
Mobile home installations require special parts (listed following)
available for purchase from your local Sears store or Sears
Service Center. For further information, please call t-800-4-MY-
HOME ®(t-800-469-4663).
• Mobile Home Installation Kit. Ask for Part Number 346784.
• Metal exhaust system hardware.
tL,ocst ,, re
Explosion Hazard
Keep flammable materials and vapors, such as
gasoline, away from dryer.
Place dryer at least 18 inches (46 cm) above the
floor for a garage installation.
Failure to do so can result in death, explosion,
or fire.
You will need
• A location that allows for proper exhaust installation. A gas
dryer must be exhausted to the outdoors. See "Venting
Requirements."
• A grounded electrical outlet located within 2 ft (61 cm) of
either side of the dryer. See "Electrical Requirements."
• A sturdy floor to support the dryer with a total weight (dryer
and load) of 200 Ibs (90.7 kgs).
A level floor with a maximum slope of 1 in. (2.5 cm) under
entire dryer. (If slope is greater than 1 in. [2.5 cm], install
Extended Dryer Feet Kit, Part No. 279819.) Clothes may not
tumble properly and dryers with automatic sensor cycles may
not operate correctly if dryer is not level.
Do not operate your dryer at temperatures below 45°F (7°C). At
lower temperatures, the dryer might not shut off at the end of an
automatic cycle. Drying times can be extended.
The dryer must not be installed or stored in an area where it will
be exposed to water and/or weather.
Check code requirements. Some codes limit, or do not permit,
installation of the dryer in garages, closets, mobile homes, or
sleeping quarters. Contact your local building inspector.
NOTE: No other fuel-burning appliance can be installed in the
same closet as a dryer.
Loading ...
Loading ...
Loading ...