Loading ...
Loading ...
Loading ...
ecornrnended Accessories
Use only Dremel accessories. Follow instructions that accompany accessories. Use of improper accessories may cause haz-
ards.
LEG SET
Cat. No.
16500 Scroll Saw Stand
Saw Blades
Dremel offers both Plain and Pin-End 5 inch blades.
PIN-END
Pin-End blades permit relatively tight radius cutting in hard and soft wood.
Cat. No. Suggested Usage Width Thick TPI Speed
16412 For cutting wood 3/8" to 2" thick .110" x .018" x 10 Any
16411 For cutting wood 3/16" to 1"thick .110" x .018" x 15 Any
16413 For cutting wood thinner than 1/4" thick .070" x .010" x 18.5 Any
PLAIN-END
The Pin-End blades, while somewhat easier to put in and take out of the machine, do not always produce the same controlled
cutting action provided with the Plain-End blade. These narrow Plain-End blades allow the user to cut more detailed, intricate
patterns and smaller inside cuts.
Cat.No. Suggested Usage Width Thick TPI Speed
16453 For cutting hard and soft woods 1/4" to 2" thick .062" x .020" x 9.5 High
16446 For close radius cutting in materials 1/8" or thicker .038" x .016" x 12.5 High
16443 For very tight radius work in thin materials, up to 1/8" .029" x .012" x 20 High
16440 .022" x .010" x 28 High
16448 .045" x .017" x 11.5 High
SPIRAL
Saws in all directions without turning the workpiece.
Cat. No. Suggested Usage
16461 For wood, plastic and abrasive materials
16463
Kerr TPI Speed
.028" - .030" x 46 Any
.034" - .036" x 41
METAL PIERCING
For cutting precious and non-ferrous metals; these must be used at very slow speeds. They perform well on machines
that have variable speed capability and should be lubricated with beeswax, or a light machine oil.
Cat. No. Suggested Usage Kerr TPI Speed
16483 Metals and other hardwood materials. .033" x .016" x 36 Low
REVERSE TOOTH
Provides a smooth, splinter free finish. Eliminates the need for excessive finish sanding, and leaves a clean sharp edge on
both the top and bottom of your workpiece.
Cat. No. Suggested Usage Kerr TPI Speed
16431 For cutting hard or soft woods up to 1/8" thick. .029" x .012" x 20 Any
16432 For cutting hard or soft woods 1/8" or thicker .038" x .016" x 12.5 Any
16433 For cutting hard or soft woods 3/8" to 2" thick .047" x .017" x 11.5 Any
PERMA-GRIT TUNGSTEN CARBIDE
Shapes and cuts ceramic tiles cleanly and accurately. Cuts intricate patterns easily in any direction. Also use for thin
wood. Not for use on ceramic floor tile.
Cat. No. Suggested Usage
16471 For very tight radius work in cearmic tile or thin wood.
16472 For close radius cutting in ceramic tile or thin wood.
Kerr Grit Speed
.031" x .033" 60 Medium
.046" x .048" 120 Medium
18.
Loading ...
Loading ...
Loading ...