Loading ...
Loading ...
Loading ...
5
6. DISCHARGE ELBOW & DISHWASHER CONNECTIONS
5. LOCKING MOUNTING ASSEMBLY DETAIL
The lower mounting ring (which is
part of the disposer) has 3 tabs that
grab the mounting ring ramp.
(A) points to the Upper Mount Ring.
(B) is the tab that slides up onto the
“Ramp”.
(C) is the "Ear" that is used to help
rotate the Lower Mount Ring.
Use a screwdriver for leverage if
needed.
Lift and turn the Lower
Mount Ring counter clock-
wise until all three mount
tabs lock over the Ridges
(F) on the slide-up Ramps
(D) of the Upper Mount
Ring.
As the Lower Mount Ring is turned counter
clockwise each tab slides up onto the Upper
Mount Ring Ramp (E) and locks in position over
the Ridges (F).
Use a screwdriver or hammer for leverage if
needed.
If a disposer needs to be removed, tapping on
the Ear clockwise with a hammer will easily
loosen the Lower Mount Ring.
Attach disposer onto the Upper Mount Ring by aligning the three mount tabs on the Lower Mount
Ring with the slide-up Ramps on the Upper Mount Ring and rotating counter clockwise. See Below.
A
C
B
D
F
E
A. Connect bottom of the elbow by tightening
the slip nut (see 6A).
If you are connecting to a dishwasher,
see B. If not, make sure all plumbing
connections are tight and in accordance
with all plumbing codes and ordinances.
Run water and check for leaks.
B. Connect dishwasher hose (6B) using a
hose clamp. Make sure all plumbing
connections are tight and in accordance
with all plumbing codes and ordinances.
Run water and check for leaks.
6A
*
AIR GAP
*Air gap may not be required for all
installations. Check local plumbing
codes.
DISPOSER
RUBBER
HOSE
DISHWASHER
HOSE
DRAIN
6B
4. ATTACHING DISCHARGE ELBOW
Connect the waste elbow to the
disposer with the Elbow Flange
and Screw Set provided.
RUBBER
GASKET
3. DISHWASHER CONNECTION PREPARATION
KNOCK
OUT PLUG
WOOD OR
METAL DOWEL
If you are utilizing a dishwasher, complete the following procedure.
Using a blunt instrument (steel punch or wooden dowel), knock out entire plug. Do not use a
screwdriver or sharp instrument. (When knockout plug falls into disposer, you may remove it
or grind it up when the disposer is used. This will not damage the disposer in any way, but it
may take some time to grind).
Loading ...
Loading ...
Loading ...