Loading ...
i i_iFULL ON E YEAR WARRAN _ ON CRAFTSMAN SCROLL SAW
If within Oneye&_from the date of purchase this craftsman SCroll Saw fails due to a defect in material or work-
•manship, Sears will repair it free of charge.
WARRANTY SERVICE IS AVAILABLE BY SIMPLY RETURNING THE CRAFTSMAN SCROLL SAW TO THE
NEAREST SEARS RETAIL/CATALOG STORE OR SERVICE CENTER/DEPARTMENT IN THE UNITED
STATES.
THIS WARRANTY APPLIES ONLY WHILE THIS PRODUCT tS USED IN THE UNITED STATES.
This warranty gives you specific legal rights and you may also have other rights which vary from state to state.
_I_ Sears. Roebuck and Co., D817 WA Hoflman Estates, IL. 60179 ._
safety instructions for scroll saw
Safety is a combination of common sense, staying alert
and knowing how your scroll saw works. Read this man-
ual to understand this saw.
Safety Signal Words
DANGER: means if the safety information is not followed
someone will be seriously injured or killed.
WARNING: means if the safety information is not fol-
lowed someone could be seriously injured or killed.
CAUTION: means if the safety information is not followed
someone might be injured.
BEFORE USING THE SAW
IWARNING: To avoid mistakes that could cause serf [
Ious permanent injury, do not plug the saw in until i
Ithe following steps are completed.
- NEVER STAND ON TOOL Serious injury could occur
if the tool tips or you accidentally hit the cutting tool, Do
not store anything above or near the tool where any-
one might stand on the tooi to reach them,
To avoid injury or death from electrical shock:
• GROUND THE SAW. This saw has an approved 3 con-
ductor cord and a 3-prong grounding the plug. Use
only 3-wire, grounded outlets rated 120 volts, 15
amperes (arnps), The green conductor in the cord is
the grounding wire, To avoid electrocution, NEVER
connect the green wire to a live terminal,
• Make sure your fingers do not touch the ptug's metal
prongs when plugging or unplugging the saw
BEFORE EACH USE:
.- Assembly and af gnment (See pages 7-12) Inspect your saw
• earn the tJSe and funct0n of the's eed contm|:ON_ . - • " "
L ...... P DISCONNECT THE SAW. To avoid injury from accidental
OFF knob, beve 10ckknob blade ho ders blade SUp- starin un lug the saw turn the sw tch off and remove
= - g, P
rt hold down, tension knob and blade guard (See
pol ; ' , - the switch key before changing the setup, removing cov-
pages: 13-14) : ers, guards or blade.
- Review and uriderstand all safety instructions and
operating procedures in this manual.
• Review of the maintenance methods for this saw: (See
page i8)Read the WARNING label below, found on
the base of the saw.
WHEN INSTALLING OR MOVING THE SAW
AVOID DANGEROUS INVIRONMENT. Use the saw in a
dry indoor place, protected from rain. Keep work area
well lighted.
To avoid injury from unexpected saw movement:
• Turn saw off and unplug cord before moving the saw.
o Put the saw on a firm level sudace where there is
plenty of room for handling and properly supporting the
workpiece.
• Support the saw so the table is level and the saw does
not rock.
- Bolt the saw to the work surface if it tends to slip, walk,
or slide during operations like cutting long heavY
boards, or when using an auxiliary table.
ILWARNING t
Loading ...
Loading ...
Loading ...