Loading ...
Loading ...
Loading ...
removing and instaUling bRades
WARNING: TO avoid Injury front accidental
Starting, always turn switch OFF and remove
switch key before removing or replacing the
blade. _ TENSION KNOB
1: Loosen tension on blade by turning tension knob
counterclockwise ( _ ) about three full turns.
2. Remove blade by pulling forward on blade and
then lifting the blade through the access hole in the SLIGHT PRESSUREHERE
table.
Slight downward pressure against the upper arm
may be helpful when removing blade from upper_"___
holder.
t) ovD
._'___ F BLADEGUARD REM E
, !
3, Look at the blade holders closely and notice the
blade slots and pin recesses in the blade holder. The
blade holder is made so you can position the blade for
cutting from the front or one side of the saw.
Cutting from the side of the saw will be necessary
when your workpiece exceeds 16 inches in length. For
0° bevel angle only.
BLADE GUARD REMOVED
FOR CLARITY
10
Loading ...
Loading ...
Loading ...