Loading ...
Loading ...
Loading ...
Before Moving Washer To A New Location
1. Remove electric plug from socket.
2. Remove electrical ground wire if one was used.
3. Coil electrical power cord and tape to back of washer.
4. Turn off water faucets.
5. Remove water inlet hoses from faucets and washer.
6. Remove drain hose from standpipe or tub. Tape drain hose
to washer. Do not let it kink.
7. Tape sides of washer to base at bottom about 4 inches in
from back.
8. Prop washer up about 4 inches on a block of wood. Loosen
lock nuts on front legs. Remove and save front legs and lock
nuts.
9. Push rear leveling legs up and tape securely.
of the washer basket and lid
EXCEPTintheareawherethe
probe of the safety lid switch
enters the washer.
11. Tape washer lid closed. _/
12. Washer is ready for moving.
NOTE: When washer is reinstalled, use new inlet hoses.
Service Saver Instructions
If your washer is not operating properly, check (and correct) the following before calling for service.
WON'T DRAIN
o
WON'T FILL WON'T SPIN
YELLOW SHIPPING STRAP WITH KEYS AND PEG NOT COMPLETELY REMOVED. • REMOVE STRAP.
NUTS ON FRONT 1-'_1_'1"NOT TIGHT. • TIGHTEN NUTS.
REAR LEVELING LEGS NOT SET. • SET REAR LEVELING LEGS.
WASHER IS NOT LEVEL. • LEVEL WASHER.
FLOOR NOT STRONG ENOUGH TO SUPPOI_T FIT.T._.nWASHER (APPROX. 315 LBS.). • RELOCATE WASHER.
LOAD OFF BALANCE. •. REDISTRIBUTE LOAD.
END OF DRAIN HOSE MORE THAN 72 INCHES ABOVE FLOOR. • LOWER DRAIN HOSE.
DRAIN HOSE KII_KI:;DOR PLUGGED. • STRAIGHTEN OR UNPLUG HOSE.
DRAIN CLOGGED. • CLEAR DRAIN.
DRAIN HOSE LESS THAN 34 INCHES ABOVE FLOOR. • R,_T._F.DRAIN HOSE.
DRAIN HOSE t"t'l'_ TIGHTLY INTO STANDPIPE. • ADJUST DRAIN HOSE FOR LOOSE FIT.
STOPS
OPERATION
POWER CORD NOT PLUGGED INTO ELECTRIC OUTLET. • PLUG IN CORD.
FUSE BLOWN OR CIRCUIT BREAKER OPEN. ' • REPAIR CIRCUIT
CONTROL ON "OFF" OR TIMER KNOB NOT PUT.T._D OUT. • SET AND PULL OUT KNOB'
WATER INLET HOSES PLUGGED OR KINKED. • FLUSH OR STRAIGHTEN HOSESI
WATER INLET VALVE SCREENS PLUGGED. r O CLEAN sC_N s
WAT_t FAUch--I'_ OFF. • TURN ON BOTH FAUCETS FULLYI
LOW WATER PRESSURE. • CORRECT PLUMBING
SUDS LOCK - CAUSED BY TOO MUCH DETERGENT. • REWASH WITHOUT DETERGENTI
LID IS OPEN. ' • CLOSE LID.
WASHER AT PAUSE IN PERMANENT pBF._ CYCLE. ALLOW CYCLE TO CONTINUE.
FOR EACH CONDITION, CHECK ALL SUGGESTED CAUSES. REFER TO INSTALLATION INSTRUCTIONS FOR CORRECT
INSTALLATION. IF NOT CORRECTED, CALL SEARS SERVICE. PLEASE HAVE MODEL NUMBER AND PURCHASE DATE READY.
i H
S_EAIRS
SEARS, ROEBUCK AND CO., 3333 Beverly Road, Hoffman Estates, IL 60179
®
Printed on recycled paper.
10% post consumer waste/
50% recovered materials.
PART NO. 3361040 Printed in U.S.A.