Loading ...
Loading ...
Loading ...
STEP 12
Use a carpenter's level to make sure washer is level front to
back and side to side. You may use a pan of water filled
to a mark instead of a carpenter's level.
TO LEVEL WASHER
• Determine which side of washer should be raised or
lowered.
• Prop front of washer up on a wood block about 4".
• Adjust front legs by turning them in or out (loosen lock
nut to turn legs in).
• Turn lock nuts until they touch washer base.
• Remove wood block and gently lower washer to the
floor.
• Adjust rear leveling legs. Tilt washer forward to raise
back about 1 inch. Set back on floor.
• Check to see if washer is level, If not repeat steps
above.
When washer is level, tighten lock nuts on the front legs
with a %_" open end wrench,
VERY IMPORTANT: BE SURE LOCK NUTS ARE
TIGHT TO PREVENT VIBRATION.
STEP 13
BE SURE WASHER IS GROUNDED AS SHOWN ON PAGE 1.
Push the washer cycle selector in and turn it right to OFF. Plug
the electric power supply cord into a grounded receptacle if
you have followed the instructions for grounding the washer.
Read all the operating instructions for your washer. Then run
it through an entire cycle. Keep literature handy in a binder
or drawer for future use.
7
Loading ...