Loading ...
Loading ...
TYPICAL INSTALLATIONS OF SEARS AUTOMATIC WASHERS
These drawings show you a choice of ways to install your washer.
Study the drawings to see which one applies to you.
STANDPIPE INSTALLATION LAUNDRY TUB INSTALLATION
Cold WaterOuUet
Hot Water Outlet
2" Minimum
Standpipe
Installation
End of Drain
Hose
34" Minimum
72" Maximum
From Floor
-_ Electrical Outlet
•,,_", Cold Water Inlet
,._.'. Hot Water Inlet
_"_ Drain Hose Outlet
._, ,_1
Cold Water Outlet
Hot Water Outlet
Electrical Outlet
Laundry Tub
Installation
End of Drain
Hose
34" Minimum
72' Maximum
From Floor,
l
", Cold Water Inlet
. i Hot Water Inlet
Drain Hose Outlet
,._J
*The drain hose assembly must fit in the standpipe so that there is an air gap around the drain hose inside
the standpipe. A snug fit can cause siphoning action.
RECESSED AREA INSTRUCTIONS
14" MAXIMUM -_b._
p--
FRONT VIEW
(DOOR NOT SHOWN)
0"
SIDE VIEW
(DOOR SHOWN)
3"
3"
t
FRONT VIEW
(DOOR WITH VENT)
2"
t
MINIMUM INSTALLATION SPACING
The installation spacing and door opening areas shown are
the minimum required for this washer. DIMENSIONS ARE
IN INCHES.
Too little space and vent area means there is not enough air
moving around your washer. This can cause heat and mois-
ture to build up in the air. Your washer and the area where
it's installed could be damaged.
When a door is installed, open areas of at least 48 sq. in.
top and 24 sq. in. bottom are required in the door. A
louvered door with air openings at the top and bottom is
acceptable. Minimum openings are shown above.
NOTE: Companion appliance spacings should be
considered.
Special Reminder: Make sure to shut off the water supply
faucets when the washer is not in use.
SERVICE SAVER INSTRUCTIONS ARE ON BACK PAGE.
DRAIN PROTECTOR
On installations where "chunks" of lint may cause problems
with the drain, it may be necessary to install a Drain Protec-
tor (Part No. 367031 available through your Sears service
department). The Drain Protector will stop the lint from
being discharged into the drain. Its function is to break up
the large "chunks" of lint into smaller particles and catch
threads and sl3"ings.
To install the Drain Protector, push it into the washer drain
hose as shown. Itis recommended that a short piece of hose
be placed on the outlet end to prevent splash in a laundry
tub or to insure that the Drain Protector will not fall out of
the standpipe and discharge water onto the floor.
Drain Hose Water Flow ) Adapter
From Washer Hose To
Adapter Drain
3
Loading ...
Loading ...
Loading ...