Loading ...
Loading ...
Loading ...
8
ADDING BLEACH
Turn Program Selector to a Regular Wash position.
Press the Start/Hold To Pause touchpad to commence water fill.
CHOOSE THE WASH PROGRAM
2.
3.
NOTE:
When you choose the Woollens and Bedding program, the Deep Rinse option is automatically selected for you.
You will not be able to select and use Eco Rinse and Fast Rinse with these two programs.
When you select the Drain+Spin program, there will be a delay of at least 2 minute before the washing machine
starts to spin. This delay is a pump out (Drain) period to ensure the bowl is empty of water, which is necessary before
spin commences. Even though you may have only put wet clothes into an empty bowl, the delay before spin will still
occur to be safe and to protect your washing machine.
Oxygen type - This is generally a powder type bleach. Mix the required quantity
with water and pour down the hole in the top panel during the fill when there is
some water in the wash bowl. Refer to the instructions on the bleach container.
NOTE: Bleach should NOT be used on silk, wool, rayon or drip dry clothes.
The table “YOUR PROGRAM GUIDE” shown on page 9 will help you in selecting the right program.
You can turn the Program Selector Knob to a new program position at any time. If you do move the Program Selector
Knob the effect will be different depending on the status of the machine at the time you do this, as follows:
The Program Selector knob is not a timer. Once you select a wash program, the Program Selector knob
will stay at that position for the whole wash cycle.
Chlorine type - This type of bleach should NOT be mixed with detergent. Mix
the bleach with water as per the instructions on the container.
Pour the bleach solution down the hole in the top panel during fill when there
is some water in the wash bowl.
Allow the machine to agitate for a few minutes, then let it stand for the required
time by pressing and holding the Start/Hold To Pause touchpad for 1.2
seconds to pause machine.
Turn Program Selector to Drain & Spin position and press the Start/Hold To
Pause touchpad to empty the wash bowl.
Your washing machine is now in STAND-BY-MODE and ready to wash your
clothes. If the settings shown on the control panel are what you want to use and
the Program Selector is set to the correct wash program for your clothes load,
press the Start/Hold To Pause touchpad to start your wash.
When the machine is in pause mode, moving the Knob to a new position will result in the machine resetting to the
start of the new program. (For pause mode, see “Machine in pause mode” page 11)
When the machine is running, moving the Knob to a new position will result in the machine continuing the wash
and it will show “ ” on the display with 3 consecutive short beeps to remind you that this option is not
allowed. (For machine running, see “Wash cycle in progress” page 11)
You can now wash the clothes load using detergent and your selected wash
program.
Bleaching of clothes can help to remove stains, heavy soiling and to kill bacteria.
1.
2.
Press the POWER switch “ON” (for models:
SWT8542, SWT9542) at the back of control panel
above the rating label.
1.
Turn on the taps and turn power on at the power point.
4.
Turn the Program Selector knob to choose the
wash program you want.
Close the lid.
POWER SwitchPOWER Switch
Loading ...
Loading ...
Loading ...