Loading ...
Loading ...
Loading ...
28 English
Installation Instructions
Reinstalling the Oven Door(s)
To avoid personal injury or damage to the door from it falling off its hinges:
• Make sure that the notch on the bottom of each hinge rests on the lower lip of each hinge receptacle before
trying to open the oven door.
• Flip the hinge locks toward the front of the range immediately after installation of the door.
1. Grasp the oven door on both sides, and hold it at a 15° angle from the front of the oven. Slide the hinges
into their slots, resting the bottom of the hinge arms on the hinge receptacles. Maintain the 15° angle with
one hand while pushing in on each bottom corner of the door, until the notch on the bottom of each hinge
slips over the lower lip of each hinge receptacle.
Wire connector under the right side of the door
should be connected.
2. Lower the door to the fully opened position.
3. Rotate the two hinge locks toward the oven.
4. Slowly and carefully open and close the door
completely to ensure that it is properly installed.
5. Remove any packaging from inside the oven(s).
this, use the three bolts (one on the right- upper side,
and one under the each hinge) .The upper bolt adjusts
the door horizontally. The lower two bolts adjust the
door vertically.
To adjust door vertically:
1. Remove the door, then remove 2 screws on each
door-hinge latch.
2. Adjust the bolt under each latch.
3. Re-attach and tighten the 2 screws.
4. Re-install the door.
Adjusting the Door (DOP48M86D* only)
inge
slot
inge
Loading ...
Loading ...
Loading ...