Loading ...
Loading ...
Loading ...
21English
Installation Instructions
Floor-Mounting the Anti-Tip Bracket, cont.
• Determine the required position of the anti-tip bracket, based on the diagram below. Mark the 4 mount-
• Determine the screw size. The minimum full thread depth (portion of screw threaded into wood/slab) is
3/8” (1 cm) for wood and 5/8” (1.6 cm) for concrete. (See SCREW SIZE table, below, for correct screw sizes.)
Attaching the Bracket to a Concrete Floor
1.
2. Through these holes, drill 4 anchor holes 1-1/4” (3.2 cm) into the concrete with a 3/16” masonry
bit. This hole length is longer than the anchor. Clean out the holes, and tap in each anchor so its
3. Align the bracket and anchor holes, then insert and tighten the screws.
Attaching the Bracket to a Wood Floor
1.
drilling pilot holes.
2. Drill 4 pilot holes in the wood with a drill bit (1/16” dia. for #8 screws, 1/8” dia. for #12 screws).
Align the bracket and pilot holes, then insert and tighten the screws.
SCREW SIZE
Sub-Floor Type/Floor Covering Thickness Screw Size
Concrete/wood suboor, no oor covering over
top
#8 x 1*
Concrete/wood suboor, oor covering up to 1/4”
thick
Concrete/wood suboor, oor covering over 1/4”
up to 1/2” thick
#8 x 1 1/4*
Wood sub-oor, oor covering over 1/2” and up
to 1 3/16” thick
#12 x 1 3/4*
Concrete under oor covering over 1/2” thick Purchase
separately**
Wood under oor covering over 1 3/16” thick
ANTI-TIP BRACKET PLACEMENT
Dim. DOP36M86DL* DOP48M86DL*
A 13” (33.0 cm) 3 1/2” (8.9 cm)
B 22 1/2” (57.2 cm) 22 1/2” (57.2 cm)
*Included with range;
**determine required depth
based on info in Step 3, and pur-
chase from hardware store.
Loading ...
Loading ...
Loading ...