Loading ...
Loading ...
Loading ...
6
Receiver
Mounting
Bracket
ASSEMBLY INSTRUCTIONS
8
7
6
6. Slide the downrod into the yoke of the motor assembly,
align the holes, then re-install the downrod pin and
downrod clip. Secure with the two set screws and slide
the yoke cover down until it rests on top of the motor
assembly.
Note: With wiring extending out of the downrod, measure
8 inches of lead wire and cut the excess wire with wire
cutters (not included). Then strip 1/2” of insulation from
the end of each wire.
7. Install the ball end of the downrod into the opening of
the mounting bracket. Rotate the downrod until the tab in
the mounting bracket is seated in the slot in the downrod
ball.
WARNING: The fan and/or downrod should not rotate in
the mounting bracket, if installed correctly. Failure to align
the slot in the downrod ball with the tab on the mounting
bracket may result in fan falling causing serious injury or
death.
Downrod Pin
Yoke
Downrod
Downrod Clip
Set Screw
Tab
Slot
Downrod
Mounting
Bracket
8. Place the receiver in the mounting bracket to prepare
for the wiring process.
Note: The receiver will rest directly on top of the
downrod.
5. Feed the wires coming from the yoke through the yoke
cover, canopy and downrod.
Downrod
Canopy
Yoke Cover
Yoke
5
Loading ...
Loading ...
Loading ...