Loading ...
Loading ...
Loading ...
21
PROBLEM POSSIBLE CAUSE SOLUTION
Then handle is not The carriage bolts are not Adjust the height of the handle, and verify
in position. properly seated. that the carriage bolts are properly seated.
Tighten the knobs.
The Snow Thrower The power cord is disconnected Reconnect the cord, and use the cord
does not start. from the switch. restraint to keep the cord close to the
switch.
The switch is defective. Replace the switch.
The extension cord is not Connect the plug on the Snow Thrower to
connected to the plug. the extension cord.
The extension cord is not Plug the extension cord into a live 120 V
connected to the power source. AC, 60 Hz outlet.
The overload protection switch See the section entitled Overload
has popped out. Protection Switch (Page 14).
The motor is on, but The belt is damaged. Replace the belt (see the section entitled
the rotor does not Inspecting/Replacing the Drive Belt).
turn.
The Snow Thrower The scraper is worn. Replace the scraper (see the section
leaves a thin layer of entitled Replacing the Scraper).
snow behind.
TROUBLESHOOTING
Loading ...
Loading ...
Loading ...