Loading ...
Loading ...
Loading ...
Inserthexboltthroughthe upper chutecrank
bracket,handle panelsupport,and upper left
handle.Secure thebracketusingcupped
washer and hex nut.Make surethat thecupped
side ofthewasher isset againstthe contourof
the handle.
Handle Panel l
Support*
\ "<
Hex Bolt
Crank Bracket
Placetheother3/8 ID flat washer (fromthe
same groupof hardware)on theend ofthechute
crank and inserthairpinclipintoeye holeat the
end ofthe chutecrank. See Figure7.
Slidethe upperchute crank throughtheplastic
bushinginthe upperchute crank bracketand
then intothe lowerchutecrank. See Figure8.
Alignthe holeson thetwo piecesofthe chute
crank,and securewith hairpinclipfrom groupC
ofthe hardwarepack.
Adjustthe chutebracketso thatthespiralon the
chutecrankfully engagesthe teeth onthe chute
assembly.
Using a wrench, tightenthe hex boltand the hex
nut onthe upperchutecrank bracket.
Fullyrotatethechute, usingthe chute crank, to
make surethat itmovesfreely.Tightenthe nuts
on the lowerchutecrank bracketsecurely.
* This part isalready attached inside the handle panel
Figure 5
You may have to loosenthe carriage boltsand
hex locknutswhichsecurethe lowerchute
crank brackettothe extensionon theleftside of
the chute assembly.See Figure6.
L rrlage Bolt,
CrankBracket ItexLockNut
Figure 6
Place one 3/8 ID flatwasher (fromgroupG of
the hardware pack) on theend ofthe chute
crank,then insertthe end ofthecrank intothe
eye holeinthe plasticbushinginthechute crank
bracket.See Figure7.
Cotter Pin
Flat Washer
Chute Crank
Tilt Upper
Chute Chute
Cables
Crank
\
Upper
Chute
Crank
Bracket
LowerChute
Crank
Flgure 8
Slipthecables thatrunfrom the handle panelto
thechute intothecable guidelocatedon topof
theengine. See Figure9.
Cable Guide
Flat Rasher
Lower Chute /
Crank Bracl_t
Figure 7
Figure 9
8
Loading ...
Loading ...
Loading ...