Loading ...
Loading ...
Loading ...
Attaching Turn Triggers
Make surethatthe righthandtriggercable is
routedinfrontofthetractiondrivecable.
• Feedthetriggercableupthroughthe outersideof
theslotinthe handlepanel.Donotfeedthecable
throughthesamesideoftheslotastheZ fitting.
• Placethecablebarrelfitting intothe holeinthe
trigger.You canfindthetriggersandassociated
hardwareingroupHofthehardwarepack(on
page5). Pullonthe cable and rotateitaroundthe
bottomofthetrigger,withtheinnercable inthe
slot,untilthecable endcan bepushedintothe
triggerhousingand snappedtight.See Figure12.
Trigger
Assembly
Inner Cable
Y
Barrel Slot
Fitting
thisend
Figure 12
Note: When the cable isinstalled correctly, itshould
not be possibletopullcable out ofthe trigger housing.
Place the rightturntriggerinposition
underneaththe righthandle.Secure withscrew
and weld nutfrom group Hof thehardware
pack. See Figure 13. You willneed a phillips
screwdriverfor tighteningthe screw. Repeat on
leftside.
Turn
S_ot ,Trigger
Cable
Figure 13
• Secure therightturntriggercable tothe right
lowerhandle, usingcable tieprovidedinthe
hardware pack. Make sure to routethecable tie
over thedrivecable. See Figure 14.
Figure 14
Secure the leftturntriggercable to the lower
handle usingthe othercable tie. Make sureto
route the cable tie below the auger drive cable
sothat when the trigger cable is securedby the
cable tie, the auger drive cable is left outside the
cable tie.Trim excess ends from eachcable tie.
NOTE: The right sidecable tiemust be used tokeep
cable from comingin contact withthemoving shift
armfromthe transmission.
Lamp Wiring
• Wrapthewirefrom thelampdownthe right
handle.Plugwireintothe aitemator leadwire
underthefuel tank. See Figure15.
I _ Hsn le
Figure 15
IMPORTANT: Assembleyoursnowthrower, then
checkthe adjustmentsas instructedand make any
final adjustmentsnecessarybeforeoperatingthe unit.
Failureto follow the instructionsmaycause damage
tothe snowthrower.
10
Loading ...
Loading ...
Loading ...