Loading ...
Loading ...
Loading ...
15
BUILT-IN
ASKO dryers can be installed beneath a cabinet
or worktop with a minimum height of 864 mm.
There must be a gap of about 12 mm all around the
machine and a minimum gap of 25 mm between the
rear edge of the machine top panel and the back
wall. The opening width must be at least 622 mm.
The condensing models work best when they have
good air circulation.
Install the dryer so the condensed water will
continuously fl ow into a drain or sink, you will need
a drain outlet behind the unit. The maximum drain
height is 1016 mm.
The height adjustment for the dryer is 850 mm to
876 mm. Do not raise it higher than 876 mm.
It is very important to avoid a buildup of heat.
The warm air which is expelled from the rear of
the dryer must be able to dissipate.
Warm air which cannot dissipate could cause a
fault.
A buildup of heat could be avoided by:
• Creating a gap for the dryer in the kitchen
furniture plinth facing.
• Creating ventilation gaps in the kitchen unit.
When build under, drying times may be longer.
The dryer should not be installed next to a
refrigeration appliance. The warm air expelled from
the rear of the dryer would increase the temperature
around the refrigeration appliance heat exchanger
causing the compressor to run continuously. If it is
not possible to install the dryer anywhere else, then
the refrigeration appliance must be sealed off from
the dryer.
Ventilation Requirements of ASKO laundry
concept or closet installation
ASKO's front panel controls make it possible to
install the washers and dryers in a cabinet or closet.
Make sure there is clearance between appliances
and cabinet or wall and 25 mm minimum clearance
between the rear edge of the appliance top panel
and the cabinet or wall.
When closet or cabinet is closed by the door, we
recommend louvered doors, to ensure proper
ventilation.
Otherwise there must be ventilation openings on
the door. See illustration of dimension for ventilation
openings below:
'
12 mm
25 mm
65 mm
635 mm
1550 mm
35 mm
50 mm
1
2 mm
465 mm
65 mm
Ensure the dryer door can be opened without
hindrance after installation.
The cool air intake panel at the front of the dryer
must not be blocked or covered. Doing so could
cause a fault.
Disregarding of instructions infl uences on
appliance performance and may also result in failure
of the appliance.
Loading ...
Loading ...
Loading ...