Loading ...
Loading ...
Loading ...
5
STANDARD OR ANGLE MOUNT INSTRUCTIONS
1. Remove the downrod pin and downrod clip from the downrod. Then partially loosen the set screws in the yoke at the top of the
motor assembly (Figure 3.1).
2. Feed the fan wires through the yoke cover, canopy and downrod (Figure 3.2).
3. Slide the downrod into the yoke of the motor assembly. Align holes and reinstall the downrod pin and downrod clip and secure
with the two set screws (Figure 3.3).
4. Depending on the length of downrod you use, you may want to cut the fan wires to simplify wiring. After pulling the wires all
the way through the downrod, measure 8 inches of wire. Cut off the excess wire using wire cutters (not included) (Figure 3.4).
5. Install the ball end of the downrod into the opening of the mounting bracket (Figure 3.5). WARNING: Failure to align the slot
in the ball with the tap on the mounting bracket may cause the fan to fall, which could result in injury or death. Then, insert
the receiver inside the mounting bracket with the at side facing the ceiling.
Skip to FINAL INSTALLATION, page 6.
8 in.
Figure 3.1
Figure 3.5
Figure 3.3
Downrod Clip
Mounting
Bracket
Downrod
Set Screw
Downrod
Receiver
Downrod Pin
Downrod
Tab
Canopy
Slot
Yoke Cover
Downrod
Clip
Set Screw
Yoke
Downrod
Pin
Figure 3.2
Figure 3.4
Loading ...
Loading ...
Loading ...