Loading ...
Loading ...
Loading ...
Water Connection
This section applies only to dryers
with a water connection. The
connection is found at the top
back of 500 and 800 Series
Dryers with the Steam logo on the
panel.
%;;
Steam
Steam Dryer Parts Supplied
The following parts are included with
the shipment of your dryer:
2
0 3
4
supplied parts illustration. It is
illustrated separately from the hose
for clarity.
3. If space permits, attach the
internally threaded (female) end of
the "Y" connector directly to the
cold water faucet (option A as
shown in the illustration above)
and continue to step 6
For optional Installation with Y
Connector
If the "Y" connector cannot be
attached directly, use the short
hose provided to connect the "Y"
connector to the cold water faucet
(option B as shown in the
illustration below), and continue
with steps 4 through 5.
Attach the dryer water supply hose to a
cold water faucet (the faucet must be
located within 4 ft (1.2 m) of the water
inlet valve on the back of the dryer).
It is recommended to have a water
supply pressure of 20 100 psi (1.37
6.89 bar) for best performance.
Since most connections will share the
cold water faucet used by the clothes
washer, a "Y" connector is provided
along with a short hose (if needed) in
order to connect the water supply hose
to the cold water faucet.
1. "Y" connector
2. Short metal-braided inlet hose
3. Rubber washer (inserted in female
end of short inlet hose, shown
separately here for purposes of
clarity).
4. water supply hose
Connecting the Water Inlet Hose
D The dryer must be connected to
the "Y" connector using the water
supply hose provided. Do not use
an old hose.
1. Turn off the cold water tap and
remove the washer water supply
hose from the tap.
4. Attach the short hose to the cold
water faucet. Tighten the
connection by hand until the
coupling is seated on the faucet.
5. Use pliers to tighten the
connection an additional
two thirds turn.
2. Check to be sure that the rubber
washer is fully inserted and seated
in the female end of the short hose
prior to continuing. The rubber
washer is shown as item 3 in the
D Do not overtighten. Damage to
the coupling could result.
13
Loading ...
Loading ...
Loading ...