Loading ...
Loading ...
Loading ...
INSTALLATION
- 5 -
Carefully pull back the gasket from the interior door
frame as indicated. Insert screws into holes on
back side of door under the door gasket. Position
the handle on the outside of the glass door.
Gently press and thread the gasket back into
the slot on the door frame. Ensure the gasket is
properly seated prior to using the unit.
The stainless steel handle is easily attached
to the left side of the glass door with two
enclosed screws.
Tighten both screws until the door handle is flush
with the stainless steel frame. Take care not to
over tighten the screws, as this may damage the
handle or frame.
IMPORTANT: NEVER LAY THE WINE AND BEVERAGE CENTER ON ITS BACK.
The compressor and motor components are installed at the back of the unit and may easily be
damaged if the wine and beverage center is placed on its back.
IMPORTANT: DO NOT USE STAINLESS STEEL HANDLE TO MOVE OR LIFT THE UNIT.
HANDLE INSTALLATION
TOOLS NEEDED: Phillips screwdriver #2.
1
2
3
4
Loading ...
Loading ...
Loading ...