Loading ...
Loading ...
Loading ...
i ' /'
/ .......
/
/
i is
..........i i'
AugerBeltReplacement
To remove and replace your snow thrower's auger belt,
proceed as follows:
1. Remove the plastic belt cover on the front of the
engine by removing the two self-tapping screws.
• Drain the gasoline from the snow thrower, or place
a piece of plastic under the gas cap.
• Carefully pivot the snow thrower u ) and forward so
that it rests on the auger housing.
2. Remove the frame cover from the underside of the
snow thrower by removing four self-tapping screws
which secure it.
3. Roll the auger belt off the engine pulley.
4. Unhook the support bracket spring from the frame.
• Loosen and remove the shoulder screw which acts
as a belt keeper.
• Remove the belt from around the auger pulley, and
slip the belt between the support bracket and the
auger pulley
• Reassemble auger belt by following instructions in
reverse order.
IMPORTANT: Do NOT forget to reinstall the shoulder
screw and reconnect the spring to the frame after
installing a replacement auger belt.
_t
'%\
t7
,/
16
Loading ...
Loading ...
Loading ...