Loading ...
Loading ...
Loading ...
Aboutthe temperaturecontrols, gecom
J
The temperature controls are preset in the factory at 37°F for the
refrigerator compartment and O°Ffor the freezer compartment. Allow
24 hours for the temperature to stabilize to the preset recommended
settings.
The temperature controls can display both the SET temperature
as well as the actual temperature in the refrigerator and freezer.
The actual temperature may vary slightly from the SET temperature
based on usage and operating environment.
Setting either or both controls to OFFstops cooling in both the freezer
and refrigerator compartments, but does not shut off electrical power
to the refrigerator.
NOTE: The refrigerator is shipped with protective film covering the
temperature controls. If this film was not removed during installation,
remove it now.
Tochange the temperature, press and release tile
WARMER or COLDERpad. Tile SETlight will come
on and tile display will show tile set teml)eramre.
To change tile teml)erature, tap either tile
WARMER or COLDERpad tlntil tile desired
temperature is displayed. Refrigerator temperatures
can be ac!justed between 34°F and 44°F and tile
fl'eezer teml)eratures can be a(!iusted between
-()°F and +6°E
Once tile desired temperature has been set,
tile temperature display will return to tile actual
reli-igerator and fl'eezer temperatures alter 5
seconds. Several a(!iusunents may be required.
Each time you a(!iust controls, allow 24 l/otu_ fin" tile
refl_igerator to reach tile temperature you have set.
Toturn the cooling system off, tap tile WARMER pad
fin" either tile reliJgerator or tile ti'eezer until tile
display shows OFF.To turn the unit back on, press tile
COLDERpad fin" either tile reli_igerator or ti'eezex:
The SETlight will ilhmfinate on the side you
selected, Then press the COLDERpad again (on the
side where the SErlight is ilhmfinated) and it will
go to tile preset points ot O°Ffi:,r tile fl'eezer and
37°Ffln" the reti'igeratox: Setting either or both
controls to OFFsmps cooling in both the freezer
and refl'igerator compartments, but does not shut
off' electrical power to tile reli'iger;mn:
PerformanceAk FlowSystem
Tile Perfimnance M>Flow System is designed to
maximize temperature control in tile refrigerator
and fl'eezer compartments. This unique special
teattu'e consists of tile :Mr Tower along tile back
wall ot the refl-igerator and the Mr Tunnel on the
bottom portion of tile fl'eezer rear wall. Placing fi)od
in front of the louvers on these components will not
affect i)ettommnce. Mthough tile Mr Tower and
tile Mr Tunnel can be removed, doing so will affect
temperature i)e_tormance. (For remox_fl
instructions, on-line, 24 llotus a day, contact us at
ge.com or call 800.GE.CARES. In Canada, contact
us at geappliances.ca or call 1.800.361.3400.)
Loading ...
Loading ...
Loading ...