Loading ...
Loading ...
Loading ...
Power Supply Cord Direct Wire
Fire Hazard
Use a new UL misted 30 amp power suppmy cord.
Use a UL misted strain reHefo
Disconnect power before making emectrical connections.
Connect neutram wire (white or center wire) to center
terminal (silver),
Ground wire (green or bare wire) must be connected to
green ground connector,
Connect remaining 2 supply wires to remaining
2 terminams (gored),
Securely tighten aH emectricat connections.
Failure to do so can resumt in death, fire, or
emectrical shock,
1. Disconnect power.
2. Remove the hold-down screw and terminal block cover.
B C D
E
F
Fire Hazard
Use 10 gauge somid copper wire.
Use a UL misted strain relief.
Disconnect power before making emectricamconnections.
Connect neutram wire (white or center wire) to center
terminal (silver).
Ground wire (green or bare wire) must be connected to
green ground connector.
Connect remaining 2 suppmy wires to remaining
2 terminals (gored).
SecureBy tighten aH emectrical connections.
Failure to do so can result in death, fire, or
electrical shock.
3. Add strain relief
Style 1: Power supply cord strain relief
• Remove the screws from a 3/4"(1.9 cm) UL listed strain
relief (UL marking on strain relief). Put the tabs of the two
clamp sections into the hole below the terminal block
opening so that one tab is pointing up and the other is
pointing down, and hold in place. Assemble and tighten
strain relief screws just enough to hold the two clamp
sections together.
A. Terminal block cover
B. External ground conductor screw
C. Center, silver-colored terminal block screw
D. Hold-down screw
E. Neutral grounding wire (green with yellow stripes)
F. Hole below terminal block opening
... J
A. Strain relief tab
B. Hole below terminal block opening
C. Clamp section
Put power supply cord through the strain relief. Be sure
that the outer insulation of the power supply cord is inside
the strain relief. The strain relief should have a tight fit with
the dryer cabinet and be in a horizontal position.
Loading ...
Loading ...
Loading ...