Loading ...
Loading ...
Loading ...
Before using for the first time
28
Setting the rinse aid dosage
You can adjust the rinse aid dosage for
best results.
The rinse aid dosage is set in stages
from 0 to 6. It is set to 3 at the factory.
This is the recommended setting.
If the "Adjust Sensor wash" programme
function (depending on model) has
been activated, the amount of rinse aid
dispensed in the Sensor wash
programme can be higher than that set.
If spots appear on crockery and
glassware:
Increase the rinse aid dosage.
If clouding or smearing appears on
crockery and glassware:
Decrease the rinse aid dosage.
Switch the dishwasher off with the
button, if it is switched on.
Press the /button in and, whilst
holding it in, switch the dishwasher
on using the button.
Keep the /button pressed in for
at least four seconds until the /
indicator light comes on.
If this does not happen, start the
procedure from the beginning again.
Press the button three times.
The indicator will flash rapidly 3
times at intervals.
The dosage set will appear in the
display after .
The flashing sequence will appear in
the display.
This indicates the factory default setting
3.
Use the / button to select the
setting required.
Each press of the button moves you
up a level. After reaching the highest
value, the counter starts from the
beginning again.
The setting is now stored in memory.
Switch the dishwasher off with the
button.
Loading ...
Loading ...
Loading ...