Documents: Go to download!
- Owner's manual - (English)
- CC 300H French Product Manual - (English)
- BEFORE FIRST USE
- SAFETY INFORMATION & WARNINGS
- INSTALLATION
- OPERATING INSTRUCTIONS
- CLEANING & MAINTENANCE
- TROUBLESHOOTING
- LIMITED MANUFACTURER’S WARRANTY
Table of contents
Owner 's Manual for NewAir CC-300H
Table of Contents
BEFORE FIRST USE
• Read and follow all the instructions below even if you feel you are familiar with the appliance.
• Remove the packing and make sure that the appliance is intact. If in doubt, do not use the appliance and contact the place of purchase.
• Do not leave packaging materials such as bags and staples within reach of children.
• Dispose of packaging carefully and with consideration for the environment.
• It is ideal to retain the appliance carton for seasonal storage.
• For your convenience, record the date you received the appliance on the warranty page of these instructions, and attach your proof of purchase. Retain this information in the event that warranty service is required.
REVERSING THE DOOR SWING
1. To reverse the door swing of the unit, remove the plastic hinge cover at top of the unit.
2. Unscrew the door hinge.
3. Flip door upside-down.
4. Attach door to opposite side of unit with screws.
5. Replace plastic door hinge cover.
SAFETY INFORMATION & WARNINGS
When using any electrical appliance, basic safety precautions must be followed in order to reduce the risk of fire, electrical shock and/or injury to persons or property. Be sure to read all instructions before using this appliance and observe the following safety tips:
Attention: To prevent the risk of child entrapment, do not allow children to operate, play with, or crawl inside the unit. If the unit will not be used for an extended period of time, remove the door and leave the shelves in place so that children cannot crawl inside. Also, remove the door when disposing of the unit.
• Never clean the appliance parts with flammable fluids, as the fumes can create a fire hazard or explosion. Do not store or use gasoline or any other flammable vapors and liquids near this or any other appliance.
• Do not store perishable foods in the cigar cooler, as the interior temperature will not be low enough to prevent food spoilage.
Shock Hazard – Electrical Grounding Required
• This cooler should be properly grounded for your safety, and in order to minimize the possibility of electrical shock, the power cord of this unit is equipped with a 3-prong plug which fits 3-prong wall outlets. Improper use of the grounded plug can result in electrical shock.
• If the power cord appears to be damaged, have it replaced by an authorized service center.
• Never cut or remove the ground wire from the supplied power cord.
• The use of an extension cord is not recommended.
• The cord should be secured behind the cooler. Also, to prevent accidental injury, do not expose or dangle the cord.
INSTALLATION
This cooler is a freestanding unit and should not be installed inside a cabinet or other built-in enclosure. For proper ventilation, allow 5 inches clearance between the back of the unit and any adjacent walls. Before operating your cigar cooler for the first time, follow these steps:
• Before connecting the unit to a power source, allow it to stand upright for approximately 2 hours. This will reduce the possibility of any system malfunctions which may have occurred from handling during transportation.
• Clean the interior surface of the unit with lukewarm water and a soft cloth but do not get the wood wet.
• Place the cooler on a level surface that will be strong enough to support the unit when it is fully loaded. To level your cooler, adjust the front feet located at the bottom of the unit.
• Install the cooler away from direct sunlight and heat sources such as stoves, heaters, or radiators. Direct sunlight may affect the unit’s acrylic coating, and nearby heat sources can increase electrical consumption. Extreme cold or hot ambient temperatures may also prevent proper performance.
• Please note: this cooler is only designed for home use, and is not designed to be placed in a garage, basement, or outdoor area
FACTORY ODOR REMOVAL
Wash the interior of the cooler with a mild detergent and warm water. Make sure to not get the wood wet. Leave the door open and allow it to air dry thoroughly. If a “plastic” smell persists, place a dish of baking soda in the unit or stuff the cooler with newspapers overnight. When finished, let the unit run a full day to complete the airing out process.
DRAWER SET-UP
The drawers and shelves included with this cooler are designed to sit flush with the front edge of the cabinet. This will allow air to circulate freely through the unit. When inserting the drawers and shelves, avoid pushing them all the way against the rear wall of the cabinet.
SEASONING YOUR CIGAR COOLER
It is best to season your wood shelves and drawers before adding your cigars so that the wood is at an ideal relative humidity (RH) and does not absorb humidity from your cigars. To season your new cigar cooler:
1. Add distilled water to the included moisture container or add a sponge that is damp with distilled water. Again, make sure that the water is not touching the wood directly or this may damage the wood.
2. Allow the moisture container, or other humidity-adding device, to sit in the cooler until it reaches a relative humidity of 5% higher than your preferred level. This process may take as long as 3 days but is the best way to ensure your cigars stay optimal.
3. Once the cooler reaches this mark, you can begin to add cigars. You may add a few at a time in order to monitor the RH and make sure it stays at a level you want it at. If it drops too much, you can use the same seasoning method to bring it back up.
During this entire process, it is recommended to not open the door unnecessarily, as this lets moisture escape and can delay the process.
OPERATING INSTRUCTIONS
OPERATING ENVIRONMENT
It is recommended that the cooler be installed in an area where the ambient temperature is between 50°- 80°F. If the ambient temperature is above or below the recommended ranges, the unit’s performance may be affected, and extreme cold or hot conditions may cause the interior temperature to fluctuate. This will prevent the optimal range of 65°- 73°F from being reached. In addition, keep in mind that the temperature may fluctuate depending on whether the interior light is on or off, and how full the cooler is.
HOW TO USE THE BUTTONS ON THE DISPLAY PANEL
BUTTON FUNCTIONS:
* The interior temperature can be adjusted in increments of 1 degree between 60° and 74°F.
After turning on the cigar cooler, the LED display will show the ambient temperature first, and then the internal cabinet temperature.
After you set the desired temperature, this set temperature will flash for 5 seconds on the display and then revert back to the internal cabinet temperature.
CLEANING & MAINTENANCE
CLEANING YOUR COOLER
To clean your cooler:
• Unplug the cooler and remove anything inside.
• Remove the shelves and drawers and wash the inside of the unit with a solution made of warm water and baking soda solution (2 tablespoons of baking soda to one quart of water).
• Unscrew the water reservoir at the bottom of the unit and rinse with water.
• To clean the outside of the unit, use a mild detergent and warm water.
MOVING YOUR COOLER
To move your cooler:
• Remove anything stored inside.
• Securely tape down all loose parts located inside the unit.
• Turn the leveling feet up to the base in order to avoid damage.
• Tape the door shut.
• Be sure the cooler stays in an upright position during transportation.
CIGAR STORAGE GUIDE
• The ideal temperature for storing cigars is between 65° and 73°F.
• The ideal relative humidity (RH) for storing cigars is between 65% and 75% RH. To properly maintain RH in the CC-300, you will need to include a method of adding humidity. For your convenience, a moisture container is included.
• To add humidity to the unit using the included moisture container, simply fill the container with distilled water or a damp sponge wet with distilled water and place it back in the unit. Please note this water should be changed after reaching the desired humidity and refilled when used again.
• Keep cigars out of direct sunlight, to avoid exposure to damaging UV rays.
• It is recommended to keep cigars in their original boxes and packaging as long as possible. Keep unwrapped cigars separate in your cooler to avoid unwanted mingling of flavors.
• Check cigars regularly for signs of tobacco beetles and mold, and take preventative measures if necessary.
• Properly stored cigars can improve with age for as long as 5-10 years, and can be kept even longer in ideal conditions.
TROUBLESHOOTING
LIMITED MANUFACTURER’S WARRANTY
This appliance is covered by a limited manufacturer’s warranty. For one year from the original date of purchase, the manufacturer will repair or replace any parts of this appliance that prove to be defective in materials and workmanship, provided the appliance has been used under normal operating conditions as intended by the manufacturer.
Warranty Terms:
During the first year, any components of this appliance found to be defective due to materials or workmanship will be repaired or replaced, at the manufacturer’s discretion, at no charge to the original purchaser. The purchaser will be responsible for any removal or transportation costs.
Warranty Exclusions:
The warranty will not apply if damage is caused by any of the following:
• Power failure
• Damage in transit or when moving the appliance
• Improper power supply such as low voltage, defective household wiring or inadequate fuses
• Accident, alteration, misuse or abuse of the appliance such as using non-approved accessories, inadequate air circulation in the room or abnormal operating conditions (extreme temperatures)
• Use in commercial or industrial applications
• Fire, water damage, theft, war, riot, hostility or acts of God such as hurricanes, floods, etc.
• Use of force or damage caused by external influences
• Partially or completely dismantled appliances
• Excess wear and tear by the user
Obtaining Service:
When making a warranty claim, please have the original bill of purchase with purchase date available. Once confirmed that your appliance is eligible for warranty service, all repairs will be performed by a NewAir™ authorized repair facility. The purchaser will be responsible for any removal or transportation costs. Replacement parts and/or units will be new, re-manufactured or refurbished and is subject to the manufacturer’s discretion. For technical support and warranty service.
See other models: NCH1K5BK00 NCH250SS01 NCH840BK00 EC111W-BLE AB-850-BLE
