Loading ...
Loading ...
Loading ...
8 www.electrolux.com
To Connect Water Supply Line to Ice Maker
Inlet Valve
Installation kit supplied with Refrigerator:
A - Adapter ½ to ¼ inch to connect the water supply
outlet to the water supply line.
B - Water supply line ¼ inch with 3 meters in length.
C - ¼ inch connector to connect the water supply line
to the refrigerator tube.
1. Disconnect the refrigerator from the power
source.
2. Attach the adapter (item A above) to the
water line, connect the water supply line
(item B) to the adapter (item A) while holding
the other end of the water supply line in a
bucket or sink Turn on the water supply to
eliminate air and clean the water supply line.
Turn off the water supply.
3. Remove the plastic protector from the
refrigerator tube and connect the water
supply line (item B) to the refrigerator tube
using the connector (item C) as shown in fig.
Make sure the tubes are inserted completely
into the connections.
4. Wrap excess water supply line behind
refrigerator so that it does not vibrate with
refrigerator operation. Do not twist the pipe.
5. Turn on the water supply, check that there
are no leaks in the connections.
6. Reconnect the refrigerator to the power
source.
7. The Ice Maker is factory-switched, within 24
hours your refrigerator will have produced
ice, discard the first production.
Note: Expect the first ice harvest within first 24
hours of unit operation. To prevent any issues
concerning ice production, please ensure that
all water lines are primed . See “Priming the
water supply system “in the “AUTOMATIC ICE &
WATER DISPENSER” section.
IMPORTANT
Your refrigerator’s water supply system
includes several tubing lines, a water filter,
and a water valve. To ensure that your water
dispenser work properly, this system must be
completely filled with water when your
refrigerator is first connected to the household
water supply line.
Water Filter
The water filter should not be used on water
that is micro biologically unsafe or with water
of unknown quality. The service life of the filter
may be reduced in water supplies that contain
an excess of particles or other impurities.
Reduced flow rate is an indication that a new
filter is required. Failure to replace the filter
when required can affect the function of the
ice maker. Service calls caused by a failure to
replace the filter are not covered by warranty.
Replacement water filters are available from
Electrolux Home Products Spare Parts Centres
and can be posted to you for your convenience
(refer to spare parts contact numbers on the
warranty page).
Plastic
cap
Remove
the cap
from the
inlet tube
¼
inch
water
valve
plastic
tube
Figure
plastic
A
C
Connector to
connect the water
supply line to the
refrigerator tube
Adapter to connect the
water supply
Figure 3
Loading ...
Loading ...
Loading ...