Loading ...
Loading ...
Loading ...
ENGLISH 21
1. Ensure that the ice maker is turned off
2. Remove the filter by turning anti-clockwise
180˚
• Slide the old water filter cartridge straight out
of the housing and discard it.
3. Unwrap the new filter cartridge and using
the alignment guid e, slid e it gently into
filter housing until it stops against the filter
connection at the back of the housing.
4. Engage the filter by firmly rotating
clockwise until the filter snaps into position
(once engaged the filter cannot be rotated
further).
5. Press a drinking glass against the water
dispenser while checking for any leaks at the
filter housing. Any spurts and sputters that
occur as the system purges air out of the
dispenser system are normal.
6. After filling one glass of water, continue
flushing the system for about four minutes.
7. Turn on the ice maker.
8. When the filter has been replaced press and
hold the ‘Reset Water Filter’ button for three
seconds to reset the filter replace timer.
9. Replace filter cover by pushing up and
snapping into place.
Water Filter
Your refrigerator is equipped with a water
filtering system. The water filtering system filters
all dispensed drinking water, as well as the
water used to produce ice. The water filter is
located at the top right side of the fresh food
compartment.
In general, you should change the water filter
every six months to ensure the highest possible
water quality. Water filter status on the user
interface prompts you to replace the filter after
a standard amount of water (750 litres) has
flowed through the system.
If your refrigerator has not been used for a peri-
od of time (during moving for example), change
the filter before reinstalling the refrigerator
Note: When ordering your replacement filter,
please reorder the same filter type that is cur-
rently in your refrigerator.
WARNING
Use the appliance with water filter supplied by
Electrolux Home Products Pty Ltd or its autho-
rized service agent only.
For correct operation of this appliance it is
essential to observe the manufacturer’s instruc-
tions.
Replacing the Water Filter
To Remove: Pull cover towards you and cover
will drop down and allow access to filter.
To Reinstall: Push cover up towards liner and
then push towards rear of cabinet. Filter cover
will snap back into place.
It is not necessary to turn the water supply off
to change the filter. Be ready to wipe up any
small amounts of water released d uring the
filter replacement.
Loading ...
Loading ...
Loading ...