Loading ...
Loading ...
Loading ...
4
The bag opening must lie flat on the welding wire. Otherwise, welding will not work
properly. Close the cover of the device. The seal presses the bag onto the sealing wire to
create a smooth seam. Make sure that both corners of the lid are closed. If necessary,
press the top cover again so that the lid clicks in audibly and firmly. Select the mode
(dry or wet). When the selection is , the indicator lights up. WhenMoist isDry Dry
selected, the indicator will light up.Moist
1.Buttons:
1) External Vac 2) Vac 3) Seal
4) Dry 5) Moist 6)Cancel
2.Indicate Light:
12) External Vac Indicator 13) Vac Indicator 14) Seal Indicator
15) Dry Indicator 16) Moist Indicator 17) Cancel Indicator
3.Other Parts:
7) lid 8) Snap Joint 9)Sink
10) Sealing Rubber Strip 11) External Interface /Suction Interface
Make sure that the weld is properly closed. A correct weld should be a smooth, straight
strip without wrinkles.
Wait 15 seconds before sealing the next bag to allow the appliance to cool down.
Fill the bag in such a way that no food residues or liquids can escape and enter the
machine during sealing.
Parts
4
6
1
2
3
5
7
11
Open the device cover by pressing the cover release and fold the cover upwards.Place
the open end of the bag in the machine so that the opening of the bag lies centrally
under the lower sealing ring. The bag should not be inserted further than the rear
ring and must lie between the front and sealing rear sealing ring. If the bag lies over
one or both of the sealing rings, the bag cannot be properly sealed.
9
8
10
12
13
14 1615 17
Loading ...
Loading ...
Loading ...