DRAPER 20582 12V Cordless Air Compressor

User Manual - Page 8

For 20582.

PDF File Manual, 20 pages, Read Online | Download pdf file

20582 photo
Loading ...
Loading ...
Loading ...
5. HEALTH AND SAFETY INFORMATION
5.2 GENERAL SAFETY INSTRUCTIONS FOR COMPRESSORS
Warning: Please read the following instructions carefully failure to do so could lead to serious
personal injury.
Important: Draper Tools recommends that this compressor should not be modified or used for any
application other than that for which it was designed. If you are unsure of it’s relative applications
do not hesitate to contact us in writing and we will advise you.
1. Know your compressor
Before operating the compressor, read and fully understand the starting, operating and
stopping sections in this manual. Read all labels affixed to the compressor. Learn it’s
applications and limitations.
2. Servicing and maintenance
Do not service or maintain this compressor until you have read and understood the
maintenance section of this manual.
3. Check damaged parts
Before further use of this compressor, parts that are damaged should be carefully checked to
ensure that it will operate correctly and perform its intended function. Check for alignment of
moving parts, breakage of parts and any other conditions that may effect its operation. A
guard or other part that is damaged should be properly repaired or replaced.
4. Disconnect from power supply
Before servicing, maintaining or replacing damaged parts ALWAYS disconnect the
compressor from the power supply.
5. Avoid dangerous environments
Do not use the compressor in damp or wet locations or expose it to rain. Keep the work area
well lit. Provide adequate surrounding work space.
6. Avoid accidental starting
Ensure the switch on the compressor is in the “off” position before connecting to a power
supply.
7. Never leave the compressor running unattended
Disconnect from the power supply. Do not leave the compressor until it comes to a complete
stop.
8. Use Recommended Accessories
Only use the recommended adaptors as supplied.
9. Overheating
Operation over an extended period of time will overheat the unit and damage the compressor.
When this occurs stop the unit immediately and do not restart until cool, approximately 20
minutes (depending on environmental conditions).
10. Keep children away
Ensure the compressor is stored out of reach of small children.
11. Tyre pressure
The gauge on the compressor is intended as a guide only. Tyre pressures should be regularly
checked against a tyre pressure gauge manufactured to BS4613, such as Draper Stock
No.26443.
Have this tool repaired by a qualified person. This tool is designed to confirm to the relevant
international and local standards and as such should be maintained and repaired by someone
qualified; using only original parts supplied by the manufacturer: This will ensure the tool remains
safe to use.
- 8 - - 13 -
8. PREPARING THE COMPRESSOR
8.2 CHARGING THE BATTERY (12V
ADAPTOR/CHARGER)
1. Unravel cord before use.
Note: Be sure the cord runs through the hole at
the base of the pack.
2. If the battery is installed, remove from
compressor as detailed in 8.1.
3. Slide the 12V Adapter/Charger pack into
compressor unit until it locks into place.
4. Connect the adapter into the DC socket in your
car.
When ready to use, power car on. Always operate
vehicle outdoors.
FIG.4
FIG.5
FIG.6
FIG.7
Loading ...
Loading ...
Loading ...