Loading ...
Loading ...
Loading ...
Preparing and loading dishes
Loading the Silverware Basket
AddingADish
Do not let any item extend through bottom.
CAUTION
Filling the rinse aid dispenser
2
2
2
2
2
2
4
4
4
4
3
3
3
3
4
4
3
3
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
11
1
1
1
1
1
1
1
4
4
3
3
3
3
3
3
4
4
4
4
2
2
2
22
2
6
5
6
The silverware basket could be divided into
three separate modules that can be used in
both upper and lower racks.
1. Spoons
2. Knives
3. Salad forks
4. Forks
5. Large spoons
6. Large forks
To add or remove items after wash cycle starts:
1. Open door slightly and wait a few seconds
until wash action stops before completely opening.
2. Add the item.
3. Press the Start/Pause pad, then close the door
latch firmly within 4 seconds, the cycle will
automatically resume.
If you close the door more than 4 seconds after
pressed the Start/Cancel pad, the cycle will
pause and not run.
TO AVOID BURN INJURY: Slightly open
door and wait until spray arms and wash
action stop. Hot water may splash out of
dishwasher. Failure to do so may result
in injury.
Be sure nothing protrudes though
bottom of the basket or rack to
block the lower spray arm.
Rinse aid greatly improves drying and reduces
water spots and filming. Without rinse aid your
dishes and dishwasher interior will have excessive
moisture. The Heated Dry option will not perform
as well without rinse aid. The rinse aid dispenser,
located next to the Detergent cup, automatically
releases a measured amount of rinse aid during
the last rinse.
If spotting and poor drying is a problem, increase
the amount of rinse aid dispensed by rotating the
dial to a higher number. The dial is located under
the dispenser cap.
If the rinse aid is low, the Rinse Aid light is
illuminated at the beginning and end of the
cycle indicating that it is time to refill.
WARNING
12
Loading ...
Loading ...
Loading ...