Loading ...
Loading ...
Loading ...
5. Make sure belt is in all pulleygrooves
and inside all belt guides.
6. Installmowerin reverseorderof
removal instructions.
Mandrel
Pulley Idler
Mandrel
Iley
TO ADJUST BRAKE
Your tractor is equipped with an adjustable
brake system which is mounted on the
side of the transaxleo
If tractor requires more than six (6) feet
stopping distance at high speed in highest
gear, then brake must be adjusted.
1_ Depress clutch/brake pedal and
engage parking brake.
2. Measure distance between brake
operating arm and nut "A" on brake rod.
3. tf distance is other than 1-9/16", loosen
jam nut and turn nut "A" until distance
becomes 1-9/16'L Retighten jam nut
against nut "A".
4. Road test tractor for proper stopping
distance as stated above. Readjust if
necessary. If stopping distance is still
greater than six (6) feet in highest gear,
further maintenance is necessary.
Contact your nearest authorized
service center/department.
With Parking Brake "Engaged"
Nut "A"
Jam Nut
Operating
Arm
*.-.,,,_ j
Do not touch this nut. If further brake
adjustment is necessary contact your
nearest authorized service center/department
TO REPLACE MOTION DRIVE BELT
Park the tractor on level surface. Engage
parking brake. For assistance, there is a
belt installation guide decal on bottom
side of left footresL
1. Remove mower (See "TO REMOVE
MOWER" in this section of this
manual.)
2. Remove belt from stationary idler and
clutching idler°
3. Pull belt slack toward rear of tractor.
Carefully remove belt upwards from
transmission input pulley and over
cooling fan blades.
4, Pull belt toward front of tractor and
remove downward from around
engine pulley.
5. Install new belt by reversing above
procedure_
Engine Pulley i _"_½
Clutching ldle_ /'_1
input Pulley i-___
TRANSMISSION REMOVAL/REPLACE-
MENT
Should your transmission require
removal for service or replacement, it
should be purged after reinstallation and
before operating the tractor. See "PURGE
TRANSMISSION" in the Operation
section of this manual.
TRANSAXLE MOTION CONTROL
LEVER NEUTRAL ADJUST[VlENT
The motion control lever has been preset
at the factory and adjustment should not
be necessary,
1_ Loosen adjustment bolt in front of the
right rear wheel, and lightly tighten°
2. Start engine and move motion control
lever until tractor does not move
forward or backward.
3. Hold motion control lever in that
position and turn engine off_
4. While holding motion control lever in
place, loosen the adjustment bolt.
24
Loading ...
Loading ...
Loading ...