Loading ...
Loading ...
Loading ...
Settings
68
Deactivate RemoteUpdate if you do not
want to install the update.
The update may take several minutes.
Please note the following information
about the RemoteUpdate function:
- You will only receive a message when
an update is available.
- Once an update has been installed, it
cannot be undone.
- Do not turn the oven off during the
update. Otherwise, the update will be
aborted and will not be installed.
- Some software updates can only be
carried out by Miele Customer
Service.
Lift-up panel
Regardless of the setting selected, as
soon as you start the Self Clean
program the lift panel will go down
automatically.
- Automatic
The lift panel raises automatically as
soon as you turn the range on.
The lift panel goes down
automatically as soon as you turn the
range off.
- Manual
Touch the Lift Panel sensor button to
raise and lower the lift panel.
Electrical version
You can set the voltage variant. The
setting must correspond to the voltage
of your domestic electrical supply.
Probe
The oven is factory set to automatically
detect the probe.
If you have purchased a new Miele
probe, you must enter a 12-digit code
for this setting. You can then start using
the probe.
Follow the description supplied with
the replacement part.
Calibrate temperature
You can change the temperature in
increments in all operating modes and
automatic programs so that it is higher
or lower in the oven compartment than
displayed.
The temperature calibration is
represented by a bar with seven
segments.
If all of the segments are filled, the oven
compartment temperature is much
higher than displayed. If one segment is
filled, the oven compartment
temperature is much lower than
displayed.
Loading ...
Loading ...
Loading ...