Loading ...
Loading ...
Loading ...
ASSEMBLY
Set the treadmill in a cleared area and remove all packing materials. Be sure that all parts are
Included before disposing of the packing materials. An adjustale wrench and standard screwdriver
are needed for assembly.
.
Insert the Lock Knob (31), with the Lock Knob Washer
(30), into the Upright Post (9). Raise the Upright Post to
a vertical position. Be careful not to pinch your
fingers. Turn the Lock Knob clockwise until it is almost
tight. Leave a little play in the Upright Post for the
following steps.
2. Align the upper end of the Side Rail (1) with the left end
of the Handrail (10). Turn the Handrail in the direction
shown to thread the Handrail into the Side Rail. (Note: If
the Handrail will not turn easily, loosen the Handrail Bolt
[7] slightly.) Tighten the Handrail and the Handrail Bolt.
3. Align the lower end of the Side Rail (1) with the hole in
the side of the treadmill Frame (54). Insert the Side Rail
Bolt (80) through the Side Rail and Frame. Reach under
the Frame and tighten the Side Rail Nut (81) onto the
end of the Bolt. Tighten the Lock Knob (see step 1).
Make sure that all parts are tightened securely before using
the treadmill.
1
80
31
OPERATION AND ADJUSTMENT
MAINTENANCE-FREE WALKING PLATFORM
This treadmill features a walking platform coated with a specially-designed hydrocarbon slip agent. Do
not apply silicone spray or any other substances to the walking platform or the walking belt.
Such substances will deteriorate the surface of the walking platform and cause excessive wear. Walk
on the treadmill for 10 minutes to break in the walking platform. During this break-in period, it is normal
for the walking belt to slow.
Loading ...
Loading ...
Loading ...