Loading ...
Loading ...
Loading ...
9
WHEN A PROPANE (L.P.) CYLINDER IS USED IN
THE ENCLOSURE
When a propane (L.P.) cylinder is installed inside of the
enclosure, the additional guidelines below MUST be
followed. FAILURE TO DO SO MAY CAUSE DAMAGE TO
YOUR UNIT AND/OR PERSONAL INJURY. Reference
Fig. 9-1 and 9-2 for an example.
• Only a C.S.A. listed stainless steel connector can be
connected to the unit.
• The regulator/hose assembly coming from the cylinder
can only be connected to the above mentioned flex
connector. DO NOT connect the regulator/hose
assembly directly to the unit. An adapter will be
required.
• A non-combustible heatshield must be installed to
protect the regulator/hose assembly and cylinder valve.
• The cylinder must rest at least 2" above the ground.
• An additional vent opening is recommended in
the access door near the cylinder and at the gas
connection level (minimum 10 sq. in. of free area).
AOG offers an "access door with tank tray and louvers"
which includes a heatshield that rests directly above
the L.P. cylinder, a tray, and louvers to meet the cylinder
install requirements. The door is shown in Fig. 9-3.
Contact your dealer for ordering information.
Fig. 9-3 Optional door w/ tank tray & louvers
Cylinder & regulator/hose assembly
protected by heatshield
Additional adapters may be required
for your setup (not included)
Equipped with
adapter for hose
assembly.
Flex connector
not included.
Fig. 9-2 Additional ventilation opening for L.P. cylinder
RHP DOOR MEETS ALL REQUIREMENTS ABOVE
Access
door
L.P.
cylinder
Ventilation
opening
(at cylinder gas
connection level,
min. 10 sq. in
free area)
(L.P. Cylinder setups only)
Louvers
Tray
Adapter
C.S.A. listed
stainless steel
flex connector
Non-combustible
heatshield
Regulator/
hose
assembly
L.P.
cylinder
3" min.
2" min.
from ground
Fig. 9-1 L.P cylinder orientation
GRILL ENCLOSURE / VENTILATION REQUIREMENTS (Cont.)
Loading ...
Loading ...
Loading ...