Loading ...
Loading ...
Loading ...
30
5. Replace burners (See BURNER REMOVAL section).
Note: It is critical to the continued safe functioning of the burners
that the orifices are centered and completely inside the
burner gas inlets.
5. Replace the vaporizer panels and the cooking grids.
6. If applicable, reinstall the control panel.
Convert/Check Backburner Orifice (if equipped)
Note: It may be necessary to remove the rotisserie rod before
beginning this procedure.
1. Remove the backburner mounting screws (
1
/
4
" hex) located at
the left end of the backburner assembly (see Fig. 30-2).
2. Carefully pull the left end of the backburner forward until the burner
can be moved to the left pulling it free from the orifice located on the
right side (see Fig. 30-3).
3. Use a
3
/
8
" hex nut driver to remove the exposed orifice. Check orifice.
If needed, replace it with the correct orifice for the new gas.
4. Replace the backburner assembly and the electrode by reversing the
procedure in steps 1. through 2.
Fig. 30-1 - Main burner orifice diagram
Orifice
Burner
Valve
The backburner orifice can be
seen on the right side after
removing the backburner.
Backburner
Orifice
Fig. 30-3
Fig. 30-2
Mounting
screws
Remove backburner mounting screws
SERVICING AND CLEANING (Cont.)
Loading ...
Loading ...
Loading ...