Loading ...
Loading ...
Loading ...
25
Table 2
If you have trouble with the unit, please use this list to identify the problem. By trying one or more of the solutions
to the possible cause, you should be able to solve the problem. If this list does not cover your present problem, or
if you have other technical diffi culties with the unit, please contact your local dealer.
PROBLEM POSSIBLE CAUSE CORRECTION
Ignition system
failure
1)
Improper air shutter adjustment 1) Adjust air shutters.
2) No spark generated at the valve
2) Retry to light. If ignition failure continues,
contact dealer for valve replacement.
3) Low gas pressure 3) Have the gas co. check supply pressure.
4) Front carry-over port 4) Clean burner ports.
5) Ignitor malfunction 5) Contact dealer for replacement.
Insuffi cient heat /
low fl ame
1)
Improper air-shutter adjustment 1) Adjust air shutters.
2) Using propane orifi ce for natural gas 2) Check/change orifi ces.
3) Low gas pressure/flame (propane) 3) Refi ll propane tank, or reset propane
tank safety*: Shut off all valves
(including propane tank) and follow
lighting instructions exactly.
4) Low gas pressure/fl ame (natural) 4) Have the gas co. check pressure at unit.
5) L.P. regulator hose cracked due to age 5) Replace L.P. regulator hose.
Uneven heating
1)
Burner ports partially blocked by debris 1) Remove burners and clean out ports.
2) Small spiders or insects in burner 2) Inspect burners and orifi ces for spider
webs or other debris that may block fl ow.
3) Improper air shutter adjustment 3) Adjust air shutter.
Rotisserie noisy
1)
Rotisserie out of balance 1) Adjust rotisserie counterbalance.
Burner goes out on
LOW
1)
Valve “Low” setting needs adjustment 1) See the VALVE "LOW" SETTING
ADJUSTMENT section for details.
Note: *Propane tanks are equipped with a safety shutdown device that may cause low or no gas/fl ame at the
burners if operating and lighting instructions are not followed exactly. If you suspect the propane tank
safety shutoff is in effect, shut off all burner control valves and the propane tank valve. Then read and
follow the LIGHTING INSTRUCTIONS exactly. Lighting instructions are located in the owner’s manual. If
the problem persists, continue troubleshooting, or contact your local dealer or distributor for assistance.
Burner goes out on
LOW
1)
Valve “Low” setting needs adjustment 1) See the VALVE "LOW" SETTING
ADJUSTMENT section for details.
5) Ignition wire disconnected 5) Reconnect wire to valve.
TROUBLESHOOTING
Loading ...