Loading ...
Loading ...
Loading ...
13
INSTALLATION (cont.)
L-C2-463
REV 0 - 1412011255
3. Turn all burner control knobs to the OFF position. Turn the
gas supply on. Then carefully check all gas connections
for leaks with a brush and half-soap/half-water solution
before lighting. Never use a match or open fl ame to test
for leaks.
4. Close the dedicated gas-supply shut-off valve.
SLIDE UNIT INTO ENCLOSURE
Slide the unit into place. Do not pinch, kink, or damage the
gas connector line.
Note: Each side of the unit has a tab just behind the
control panel. These tabs prevent the control panel
from moving inward. If the tabs interfere with the
unit sliding in (see Fig. 13-1), use pliers to bend
them inward so that they clear the enclosure sides.
Leave the tabs slightly out to ensure they still keep
the control panel from moving inward (see Fig.
13-2).
Note: Additional tabs are provided on the side and
rear panels and are only needed when installing
in combustible framing. See COMBUSTIBLE
ENCLOSURE CUT-OUT section for details.
POSITION THE BURNER CAPS
Place the burner caps so they are centered over each burner.
Ensure that they rest securely in place.
Fig. 13-1 Tab may interfere when
sliding in unit
Fig. 13-2 Tab slightly bent in for
clearance
Loading ...
Loading ...
Loading ...