Midea MDWF1W Freestanding Dishwasher

Instruction Manual - Page 16

For MDWF1W. Also, The document are for others Midea models: MDWF1SS

PDF File Manual, 21 pages, Read Online | Download pdf file

MDWF1W photo
Loading ...
Loading ...
Loading ...
13
How to Disconnect the Safety Supply Hose
Cold Water Connection
Drain Hose Connection
How to Connect the Safety Supply Hose
About the Safety Supply Hose
The safety supply hose consists of double walls. The hose system guarantees its intervention by blocking the ow of water
when the supply hose breaks and the space between the supply hose itself and the outer corrugated hose is full of water.
Counter
Front
NOTE
The top of the hose
must be less than
1000mm.
Drain Pipe
40mm
MAX 1000mm
WARNING!
The appliance must be connected to the water mains using new hose-sets.
The old hose-sets should not be reused.
Water pressure must be between 0.04 MPa and 1 MPa. If the pressure is below the minimum,
consult our Service Department for advice.
1. Pull the safety supply hoses completely out from storage compartment located at the rear of
the dishwasher.
2. Tighten the screws of the safety supply hose to the faucet with thread 3/4 inch.
3. Turn the water fully on before starting the dishwasher.
1. Turn off the water.
2. Release the water pressure by pressing the pressure release button. In this way, water
pressure will be relieved, protecting you and the room from severe splashing.
3. Unscrew the safety supply hose from the faucet.
Connect the cold water supply hose to a threaded 3/4 (inch) connector and make sure that it is fastened tightly in place. If the
water hoses are new or have not been used for an extended period of time, let the water run out rstly to make sure that the
water is clear and free of impurities. If this precaution is not taken, there will be a risk that the water inlet gets blocked and the
appliance is damaged.
Insert the drain hose into a drain pipe with a minimum diameter of 40mm, or let it run into the sink, avoiding bending or
crimping it. The top of the hose must be less than 1000mm
A hose attached to a sink spray can burst if it is installed on the same water line as the dishwasher. If you have one sink, it is
recommended that the hose be disconnected and the hole plugged.
PLEASE HANG UP THE DRAIN HOSE IN EITHER WAY OF A, B
Loading ...
Loading ...
Loading ...