Loading ...
Loading ...
Loading ...
9
Forgetting to Add a Dish
At the End of the Washing Cycle
A forgotten dish can be added any time before the detergent cup opens.
When the working cycle has nished, the buzzer of the dishwasher will sound for 8 seconds, then stop. Turn off the appliance
using the ON/OFF button, shut off the water supply and open the door of the dishwasher.
Wait for a few minutes before unloading the dishwasher to avoid scalding. The dishes and utensils are still hot and more
susceptible to breakage. They will also be dried better.
Switch off the Dishwasher
The LED screen is on but the colon icon is not blinking, and only in this case the program has ended.
1. Switch off the dishwasher by pressing the ON/OFF button.
2. Turn off the water tap.
Open the Door Carefully.
Hot dishes are sensitive to knocks. The dishes should be allowed to cool down around 15 minutes before removed from the
appliance.
Open the dishwasher's door, leave it ajar and wait a few minutes before removing the dishes. In this way they will be cooler
and the drying will be improved.
Unload the Dishwasher
It is normal that the dishwasher is wet inside.
Empty the lower basket rst and then the upper one. This will avoid water dripping from the upper basket on to the dishes
in the lower one.
Press the Start/Pause button to stop the washing. Add forgotten dishes.
Open the door a little. Close the door.
After the spray arms stop working, you can open
the door completely.
Press the Start/Pause button, the dishwasher will run after
10 seconds.
WARNING!
It is dangerous to open the door when washing, because the hot water may scald you.
Changing the Program
Premise:
A cycle that is underway can only be modied if it has only been running for a short time. Otherwise, the detergent may
have already been released, and the appliance may have already drained the wash water.
In this case, the detergent dispenser must be relled (see the section entitled "Detergent" ).
Press the Start/Pause button, the machine will be in a standby state. Press the program button for more than 3s, then you
can change the program to the desired cycle setting (see the section entitled "Starting a Washing Program" )
The LED display shows the state of the dishwasher:
a) The screen shows H MM and the colon icon does not blink------------------Stand-by or being paused
b) The screen shows H MM and the colon icon blinks-----------------------Running
NOTE:
NOTE:
If you open the door during a wash cycle , the machine will pause. The LED display window "
" will stop blinking
and the buzzer will beep every minute unless you close the door. After you close the door, the machine will keep on
working after 10 seconds.
When you press the Start/Pause button to pause during washing, the LED display window "
" will
stop blinking and the dishwasher will beep every minute unless you press the Start/Pause button
again to start.
Loading ...
Loading ...
Loading ...