Loading ...
Loading ...
Loading ...
Installation Instructions
REVERSING THE DOOR SWING (CONT.)
[] TRANSFER BOTTOM HINGE
BRACKET TO THE LEFT
For models with a base grille, remo_e it b) ,grasI)ing, it
about 6" fi'om each end and mllino its botton/edoe
t()wa rd _otl.
Using a Torx diner; moxe tile bottom hinoe bracket
and plastic washer fl'om tile fight side to tile left side.
NOT]?:: If tile washer is not on tile hinoe bracket,
check to see if it is stuck to tile bottom of tile dora:
@'_i PlasticWasher
Hinge
For models with a base grille, before rei)lacim*_ tile
base grille, remoxe tile grille cap by remoxing tile
screw. Screw tile cap to tile opposite side.
Replace tile base grille by inserting tile tops of tile
metal clips into the ox;fl vents, making sm'e one of the
plastic tabs on the back of the grille goes into each of
the oven vents. Then push the bottom of the grille
fin'ward tmtil it snaps into place.
[] TRANSFER CENTER HINGE
BRACKET TO THE LEFT
Remove tile center hinge bracket by removing tile
three Torx _'_screws.
NOTE: Keep these screws with tile hinge bracket.
They are long scrmvs and will be used when installing
the hinge on the other side.
On some models, you will need to remove tile colo>
matched caps fl'om tile screw heads befin'e you can
relnove tile screws. Lrse tile edge (ff a thin fiat blade to
gently pry the caps off tile screw heads. (A putty knife
works well for this.) Cover tile blade with tape to
prevent scratching the paint.
Remove the three Torx '_screws fl'om the center lett
side of the cabinet. Screw them into the holes on
the right side.
Place the center hinge bracket over the holes at
the center left side of the cabinet. Insert and
tighten the three hmg screws.
Replace the caps by snapping them over the screws
with your finger.
ScrewCap
e..
_D-'O i
[] TRANSFER DOOR STOPS
On each doo_; mo_e tile metal door stop ti'om tile
fight to tile left.
Moxe any screws ti'om tile left to tile fi ,ht
Stop Door Sto
LeftSide
RightSide
20
Loading ...
Loading ...
Loading ...