Loading ...
Loading ...
Loading ...
16 Cyclone Insert Installation - English
1. Remove both lters by pulling the lever to release the locking
mechanism (Figure 1).
2. Attach rubber seal and damper to rectangular cutout on top
of the range hood using the screws provided (Figure 2).
3. By removing the lters, locate the four Phillips screws. ere
are 2 on the right side and 2 on the le side. Remove the 4
screws using your screwdriver or power drill and place them
aside as you will need them later on to reattach the face.
Remove the face and set it aside.. (Figure3)..
4. Aer removing the four screws, reach into the cavity of the
hood and unplug the two wires that lead to the lights and the
one wire that leads to the switch/controls.
5. Once the three wires are unplugged, you can completely
remove the face and set it aside. With the face removed, you
will be able to identify the four mounting holes that you will
use to secure the hood to the cabinet.
6. Hold range hood upright, and insert range hood upward into
cabinet cutout. Secure the range hood to the cabinet using the
four screws provided. Two for each side (Figure 4).
7. Reattach and screw the face onto range hood. Connect the
connectors of switch and two lights.
8. Make sure that the adapter is connected to ductwork.
9. Place bae lters back into place.
10. Connect the power plug to the junction box.
Install the BX600/BX360/CLX60 Range Hood
BX600/BX360/CLX60 INSERT HOOD INSTALLATION
is appliance requires 120V 60Hz electrical supply and
connection to an individual properly grounded branch circuit
protected by a circuit breaker or time delay fuse.
• Turn o power circuit at the service panel before wiring
this unit.
• All electrical work must be done by a qualied electrician
in accordance with all applicable codes and standards.
is range hood must be properly grounded.
WARNING
• At least two installers are required due to the weight and
size of the hood.
CAUTION
Figure 1.
Prepare for Installation
1. Unpack range hood and check contents. Note: Be cautious of
sharp edges within the unit.
2. Cut the insert cutout at the bottom of the cabinet using the
given cutout measurements on page 17 (Figure 1).
3. Locate the cutout at the center of the bottom of the cabinet.
Figure 3.Figure 2.
• Prior to installation, inspect the product for any damage
or defects. Any damage and/or defects must be reported
to the vendor immediately.
CAUTION
Figure 4.
Loading ...
Loading ...
Loading ...