Loading ...
Loading ...
Loading ...
© 2021 United States Stove Company
13
TOP MAY BE
TILTED OPEN AS
INDICATED BY
ARROW
THERMOSTAT
CONTROL
KNOB
AIR
ADJUSTMENT
SHUTTER
PRESSURE
RELIEF
COVER
OPEN
OPEN
5. When the wood is burning briskly, add
additional kindling as required to establish a
good kindling re.
6. When the kindling re has been established
and is burning briskly, cover it with a thin layer of
coal. If you add too much coal you will smother
the re, requiring you to start the whole process
over again. Be patient.
7. Securely close the heater’s fuel feed door as
the coal begins burning. CAUTION: OPERATING
THE HEATER WITH ITS FUEL FEED DOOR
OR ASH REMOVAL DOOR OPENED CREATES
AN ABNORMAL FIRING CONDITION WHICH
CAN OVERHEAT THE HEATER, CHIMNEY AND
ADJACENT COMBUSTIBLE MATERIALS. THIS
CAN DRASTICALLY SHORTEN THE HEATER’S
LIFE AND VOID THE FACTORY WARRANTY.
8. Wait about ten minutes, or until the coal is
burning well, then start adding small quantities
of coal at ten minute intervals until a good coal
re is established.
CAUTION:
• NEVER ADD MORE COAL THAN IS ALREADY
BURNING AND NEVER ADD MORE THAN
TEN POUNDS OF FRESH COAL AT ONE TIME.
• WHEN FRESH COAL IS ADDED, ALWAYS
LEAVE SOME OF THE GLOWING COALS
UNCOVERED.
• NEVER FILL THE HEATER SO THAT THE
BURNING COAL IS ABOVE THE TOP OF THE
HEATER’S CHAMBER LINERS. THIS WILL
CAUSE THE HEATER TO OVERHEAT AND
WILL SHORTEN ITS LIFE.
9. MAKE SURE THAT THE HEATER’S FUEL FEED
DOOR, ASH REMOVAL DOOR, AND CABINET
DOOR ARE SECURELY CLOSED.
10. Set the heater’s thermostat control knob to
a point midway between “HI” and “Lo”. If the
house or heating situation requires a higher or
lower setting to obtain the desired amount of
heat, adjust the heat’s thermostat control knob
accordingly.
OPENING & CLOSING FUEL FEED DOOR
OPEN: When closed and latched, the door and
handle will be as shown in position number 1. Rotate
the handle until it is as shown in position number 2.
Pull the door open until it stops, approximately one
inch as shown in position 3. Continue to hold the
door open as the handle is returned to its original
position. The door will then open completely as
shown in position number 4.
CLOSED: With the handle as shown in position
number 4, close the door as far as possible. Now
rotate the handle to position number 3 and
completely close the door as shown in position
number 2. Rotate the handle as shown in position
number 1 and apply sufcient pressure to insure
that the door is sealed.
OPERATION
Loading ...
Loading ...
Loading ...