Loading ...
Loading ...
Loading ...
7
44-lb. Clear Ice Maker
www.insigniaproducts.com
Setting up your ice maker
Before using your ice maker
• Remove the exterior and interior packing.
• Remove all tape and take out the accessories from the unit. If any parts are
missing, contact customer service.
• Clean your ice maker (see Cleaning and maintaining your ice maker
on page
10), then run two or three cycles of ice and dispose of them to remove any
plastic odor or residue from the manufacturing and shipping process.
Finding a suitable location
• Your ice maker is designed to be free standing only, and should not be
recessed or built-in.
• Place your ice maker on a counter top that is strong enough to support it
when it is fully loaded.
• Allow six inches (15 cm) of space between the back and sides of your ice
maker and any surrounding walls to allow for proper air ventilation.
• Place your ice maker away from direct sunlight and sources of heat, such as a
stove, heater, or radiator. Direct sunlight may affect the acrylic coating and
heat sources may increase electrical consumption. Extremely cold
temperatures may also prevent your ice maker from performing properly.
Providing a proper power supply
This appliance requires a standard 110-120 Volt, 60 Hz electrical outlet with good
grounding means.
12 Error code indicator E - Indicates an ice making problem or a refrigerant leak.
E1 - Indicates that the ambient temperature sensor is bad.
E2 - Indicates that the water temperature sensor is bad.
13 -/ice maker timer/ice
thickness decrease
When your ice maker is making ice, press to make thinner
ice. When setting the timer, press to decrease the time.
Press and hold for more than five seconds to switch the
temperature display between °F and °C.
WARNINGS: Before plugging in your ice maker, wait four hours for the refrigerant fluid to
settle.
WARNINGS:
Improper use of the grounded plug can result in the risk of electrical
shock. If the power cord is damaged please call our customer service.
#ICONBUTTON/DISPLAYDESCRIPTION
Loading ...
Loading ...
Loading ...