Loading ...
Loading ...
Loading ...
YournewtractorhasbeenassemMedatthefactorywithexceptionofthosepartsUeftunassemMedforshippingpurposes.
ToensuresafeandproperoperationofyourtractoraHpartsandhardwareyouassemMemustbetightenedsecureUy.Use
thecorrecttooUsasnecessarytoinsurepropertightness.
TOOLS REQUIRED FOR ASSEMBLY
A socket wrench set wHUmake assemMy easier. Standard
wrench sizes are Hsted.
(1) PHers (1) Tire pressure gauge
(2) 9/16" wrench (1) Utility knife
(1) 1/2" wrench (1) 3/4" socket w/drive ratchet
When right orUefthand is mentioned in this manual it means
when you are in the operating position (seated behind the
steering wheeU).
TO REMOVE TRACTOR FROM
CARTON
UNPACK CARTON
o Remove aH accessibUe Uooseparts and parts cartons
from carton.
o Cut aUongdotted Hnes on aH four panels of carton.
Remove end panels and lay side panels flat.
o Remove mower and packing materials.
o Check for any additional loose parts or cartons and
remove.
BEFORE REMOWNG TRACTOR FROM
STEERING WHEEL
STEERING WHEEL
INSERT
_LOCKNUT
I
_LARGEFLATWASHER
STEERING
/WHEEL ADAP-
TOR
STEERING
WHEELEXTENTION
STEERING
SHAFT
FmG.1
HOW TO SET UP YOUR TRACTOR
ATTACH STEERING WHEEL (See Fig. 1)
* Remove Iocknut and large flat washer from steering
shaft.
Position front wheels of the tractor so they are pointing
straight forward.
o Slide the steering sleeve over the steering shaft.
o Align tabs and press steering sleeve extension into
bottom of steering wheel.
o Position steering wheel so cross bars are horizontal
(left to right) and slide onto steering wheel adapter.
o Secure steering wheel to steering shaft with Iocknut
and large flat washer previously removed. Tighten
securely.
, Snap steering wheel insert into center of steering
wheel.
o Remove protective materials from tractor hood and
grill.
IMPORTANT: CHECK FOR AND REMOVE ANY STAPLES IN
SKID THAT MAY PUNCTURETIRES WHERE TRACTOR IS TO
ROLL OFF SKID.
6
CHECK BATTERY (See Fig, 2)
o Lift hood to raised position.
o If this battery is put into service after month and year
indicated on label (label located between terminals)
charge battery for minimum of one hour at 6-10 amps.
(See "BATTERY" in the Maintenance section of this
manual for charging
.... _ LABEL
FIG. 2
INSTALL SEAT (See Fig, 3)
Seat position should be adjusted forward or backward so
that the operator can comfortably reach clutch/brake pedal
and safely operate the tractor,
o Remove the two (2) bolts and flat washers securing
the seat to cardboard packing, Keep the two (2) bolts
only and place them with the two (2) identical bolts
and four (4) washers in the parts bag, Discard the flat
washers and cardboard packing,
o Release L,H, seat slide on seat pan by pulling out on
adjustment handle and sliding it to the rear position
exposing seat mounting holes from bottom, Slide R,H,
slide to same rear position,
Loading ...
Loading ...
Loading ...