Loading ...
Loading ...
Loading ...
INSTA[IATION
INSTRUCTIONS
Check that you have everything necessary for correct installation.
Proper installation is your responsibility.
• Flat-blade screwdriver • Safety glasses
• Adjustable wrench that • Vent clamps
opens to 1 in. (2.5 cm) or
hex-head socket wrench • Caulking gun and
compound (for installing
(for adjusting dryer feet) new exhaust vent)
• Level
• Gloves
• #2 Phillips screwdriver
• Tin snips (new vent
installations)
Parts supplied
Remove parts packages from dryer drum. Check that all parts are
included.
• Door Reversal Kit
i J
• Parts package
4 Leveling legs
NOTE: Do not use leveling legs if installing the dryer on a
pedestal.
Parts needed
Check local codes. Check existing electrical supply and venting.
See "Electrical Requirements" and "Venting Requirements"
before purchasing parts.
• For close-clearance installations between 31.5 in. (80.01 cm)
and 37 in. (93.98 cm), see "Plan Vent System" section for
venting requirements.
I_ 37" _I
(93.98 crn)
Mobile home installations require metal exhaust system hardware
available for purchase from the dealer from whom you purchased
your dryer. For further information, please refer to the "Assistance
or Service" section of this manual.
Pedestal
Are you placing the dryer on a pedestal? You may purchase a
pedestal separately for this dryer. This pedestal will add about
13 in. (33 cm) to the height of your unit for a total height of
approximately 51 in. (130 cm).
Optional pedestal
To order, call the dealer from whom you purchased your dryer or
refer to the "Assistance or Service" section of this manual. Ask
for Part Number LAB2700LQ (White), LAB2700LT (Biscuit) or
LAB2700LL (Pewter).
Stack Kit
Are you planning to stack your DUET®washer and dryer? To do
so, you will need to purchase a Stack Kit.
To order, call the dealer from whom you purchased your dryer or
refer to the "Assistance or Service" section of this manual. Ask
for Part Number 8541503.
E×piosion Hazard
Keep flammable materiaJs and vapors, such as
gasoline, away from dryer.
Place dryer at least 18 inches (46 cm) above the
floor for a garage installation.
FaiJure to do so can result in death, e×pIosion,
or fire.
You will need
• A location that allows for proper exhaust installation. See
"Venting Requirements."
• A separate 30 amp circuit.
• A grounded electrical outlet located within 2 ft (61 cm) of
either side of the dryer. See "Electrical Requirements."
• A sturdy floor to support the total dryer weight of 200 Ibs
(90.7 kg). The combined weight of a companion appliance
should also be considered.
Loading ...
Loading ...
Loading ...