Loading ...
Loading ...
953.152UK User Manual
Front panel
Rear panel
Connection
Ensure the Power (11) is switched off until all input and output connections are in place.
Turn all output rotary level controls (9) fully down (anti-clockwise) to avoid loud noises when switching on.
Set the BASS and TREBLE Tone controls (1, 2, 4, 5) to the vertical position (zero)
Loudspeakers should be connected to the RMS605 via screw terminals on one of 2 removable modular connectors.
If the speaker(s) being connected is not 100V type, use the terminal block marked “4Ω” for this channel (14).
Connect + and – wires to each speaker as indicated, ensuring that there is no chance of strands shorting across terminals.
Important: Ensure that the load is no lower than 4Ω for each output. This can be…
1 x 4Ω speaker 1 x 16Ω speaker
1 x 8Ω speakers 2 x 16Ω speakers wired in parallel (8Ω)
2 x 8Ω speakers wired in parallel (4Ω) 3 x 16Ω speakers wired in parallel (5.3Ω)
4 x 16Ω speakers wired in parallel (4Ω)
Ensure that the connected speakers can handle 60W from each output.
If the speaker(s) being connected to an output channel
are 100V type, use the terminal block marked “100V” for
this output channel. When connecting multiple 100V
speakers to this output, connect all speakers in parallel
and ensure that the total load is below 54W.
The wattage of each speaker can sometimes be
adjusted via tappings on the speaker (check the
speaker’s documentation if unsure)
DO NOT connect to both 4Ω and 100V terminals for any individual output channel
DO NOT mix 4Ω and 100V speakers on any single output.
THERE SHOULD BE NO CONNECTION MADE VERTICALLY ABOVE OR BELOW ANY OTHER
1.
BASS EQ – Paging Mic input
7.
Power on indicator
2.
TREBLE EQ – Paging Mic input
8.
GAIN control – Paging Mic input
3.
Signal indicator – Paging Mic input
9.
LEVEL control – Output channels
4.
BASS EQ – Output channels
10.
Status indicators – Output channels
5.
TREBLE EQ – Output channels
11.
Power on/off switch
6.
AUX/Individual channel input switch
12.
IEC mains inlet and fuse holder
17.
Paging mic VOX sensitivity control
13.
100V speaker output terminals
18.
Paging mic balanced XLR input
14.
4Ω speaker output terminals
19.
24V emergency mute terminals
15.
Line level individual channel RCA inputs
20.
Line level individual channel terminal inputs
16.
Line level AUX RCA inputs
21.
Phantom power and Vox DIP switches
Loading ...