Loading ...
Loading ...
Loading ...
Fanaway Xiao Installation Instructions
11 | P age
X I A O - M E N A R D S V e r s i o n 1 . 0 10/ 2 0 21
If the fan has light kit attached, the light will flash on and off to indicate the paring process is
activated.
⚫ Turn ON and change the speed of the ceiling fan 1 by the transmitter 1 to check the operation and
successful pairing
⚫ If pairing has been unsuccessful, repeat these set of steps again.
Transmitter / Receiver pairing for Ceiling fan 2:
⚫ Turn off the mains supply to the receivers of both ceiling fans 1 and 2.
⚫ Install the 12V battery in the compartment. Please make sure the polarity of the battery is correct.
⚫ Change the position of the DIP switches in the transmitter 2, (Fig. 18)
so that it will be different to transmitter 1. (Fig. 19)
⚫ Turn on the power to receiver 2. Keep the power OFF to receiver 1. (Each ceiling fan must have its
own isolation switch, so that only the ceiling fan that needs to be paired with the transmitter will be
ON).
Press and hold the Any button of transmitter 2 in excess of 3 seconds within 60 seconds of
switching the power ON to the receiver of ceiling fan 2.
If the fan has light kit attached, the light will flash on and off to indicate the paring process is
activated.
⚫ Turn ON and change the speed of ceiling fan 2 by the transmitter 2 to check the operation and
successful pairing.
⚫ If pairing has been unsuccessful, repeat these set of steps again.
Note: The pairing of the transmitter and receiver is not required if only one ceiling fan is
installed. When more than two ceiling fans are installed near each other, please refer to the
instruction above.
Fig. 19
Fig. 18
Loading ...
Loading ...
Loading ...