Loading ...
Loading ...
Loading ...
18 49-3000230 Rev 0
Installation Combo
Washer/Dryer
Instructions
If you have any questions, call GE Appliances at 800.GE.CARES
(800.432.2737) or visit our Website at: GEAppliances.com
In Canada, call 800.561.3344 or visit GEAppliances.ca
TOOLS REQUIRED FOR
UNIT INSTALLATION
Ŷ
Level
Ŷ
Wrench (provided)
Ŷ
Channel-lock adjustable pliers
PARTS SUPPLIED
BEFORE YOU BEGIN
Read these instructions completely and carefully.
•
IMPORTANT – Save these
instructions for local inspector’s use.
•
IMPORTANT – Observe all governing
codes and ordinances.
• Note to Installer – Be sure to leave these
instructions with the Consumer.
• Note to Consumer – Keep these instructions
for future reference.
• Skill level – Installation of this appliance requires
basic mechanical and electrical skills.
• Completion time – 1-3 hours
• Proper installation is the responsibility of the
installer.
• Product failure due to improper installation is not
covered under the Warranty.
Ŷ
Water Hoses (2)
(Flat washers
pre-installed)
Ŷ
Drain Hose
Guide
DO NOT Install the Unit:
1. In an area exposed to dripping water or outside weather
conditions. The ambient temperature should never be
below 60°F (15.6°C) for proper unit operation.
2. In an area where it will come in contact with curtains or
drapes.
3. On carpet. The floor MUST be a hard surface with a
PD[LPXPVORSHRIƎSHUIRRWFPSHUFP
To make sure the unit does not vibrate or move, you
may have to reinforce the floor.
NOTE:,IIORRULVLQSRRUFRQGLWLRQXVHƎLPSUHJQDWHG
plywood sheet solidly attached to existing floor covering.
IMPORTANT:
Minimum Installation Clearances
• :KHQLQVWDOOHGLQDOFRYH6LGHV5HDU ´DQG7RS Ǝ
• When installed in closet: Sides/Rear = 0” and Top/Front =
ƎFP
• Consideration must be given to provide adequate
clearance for installation and service.
• Closet doors must be louvered or otherwise ventilated
and have at least 60 square inches (387.1 cm
2
) of open
area. If the closet contains a second laundry unit, doors
must contain a minimum of 120 square inches (774.2
cm
2
) of open area.
LOCATION OF YOUR UNIT
MOBILE HOME INSTALLATION:
Installation must conform to Standard for Mobile Homes, ANSI A119.1 and National Mobile Home Construction and
Safety Standards Act of 1974 (PL93-383).
Ŷ
Safety Glasses
Ŷ
Gloves
Loading ...
Loading ...
Loading ...