Loading ...
Loading ...
Loading ...
BEFORE CALLING FOR SERVICE (cont.)
The display shows:
Check if... Then...
Load is too small. Add 1 or 2 similar items to help balance the load.
Load is out of balance. Pause the cycle and redistribute the load after the door unlocks.
The washer has an imbalance detection and correction
system. If individual heavy articles are loaded (bath mat, bath
robe, etc.) and the imbalance is too great, the washer will make
several attempts to restart the spin cycle. If an imbalance is
still detected, the washer will stop and the error code will be
displayed.
The display shows:
Check if...
Control error.
_F
C
Then...
Unplug the washer and wait 60 seconds. Reconnect power
and try again. If the error reappears, call for service.
The display shows:
Check if...
Water level is too high due to a faulty water valve.
Then...
I Close the the and call for service.
water
taps,
unplug washer,
The display shows: _:_F
FL-
Check if,,.
The water level is not
sensor
working correctly.
Then...
[ Close the water taps, unplug the washer, and call for service. J[
The display shows:
Check if...
t F
LC
Then...
Thermaloverload protection circuitinthe motor has
been tripped.
Allow the washer to stand for 30 minutes to allow the motor
to cool; then restart the cycle. If the LE error code persists,
call for service.
The display shows:
Checkif...
A power failure has occurred.
Then...
If the power to the washer has been interrupted during a
cycle, the "PF" error code will be displayed the next time the
washer is turned on. This will alert you to the fact that the the
previous cycle may not have been completed. Select any
cycle to clear the error code and use the washer.
29
Loading ...
Loading ...
Loading ...