Loading ...
Loading ...
Loading ...
BOTH MODELS
0
CONNECTING THE MOTOR
1. Next, the motorcord needs to be wired intothe motor
Coming from the underside of the table will be acord
with a black, white and green wire This is the motor
cord.
WARNING: Foryourown safety, neverplug the 1
saw in until all assembly steps are completed.
]
2. Loosen the two screws holding the connector box
cover on theback side ot the motor. Swing the cover
open.
3. Install the green ground wire by removing the green
grounding screw and inserting it through the round
metal terminal on the green ground wire of the motor
cord. Reinstall the green screw into the hole from
which it was removed and tighten securely.
41
.
6.
.
WARNING: To avoid electrocution, never con-
nect but the ground wire (colored green) to the
green screw.
Insert terminal end of WHITE wire on spade terminal
marked T4 on the motor. Push terminal firmly until
seated.
Insert terminal end of BLACK wire on spade terminal
marked T1 on the motor. Push terminal firmly until
seated.
Close motor connector box being sure that power
cord is seated in the largest strain relief groove and
tighten box cover screws.
DO NOT plug in power cord.
Q
17
Loading ...
Loading ...
Loading ...