Loading ...
Loading ...
Loading ...
8
6-B WALL MOUNT HIGH BACKGUARD WITH LOW SHELF/HIGH SHELF - ASSEMBLY
VENT HOOD
1
3
4
5
6
7
7
2
30” MODELS = 16” (406mm)
36/48” MODELS = 32” (813mm)
BACKGUARD
1/4”
(6mm)
COOKTOP
1 Recommended installation order:
1] VENT HOOD
2] BACKGUARD
3] COOKTOP
Locate and Mark the mounting screw locations for
back section
2 After unpacking all backguard parts, position the
back section so that it’s 1/4” (6mm) and centered
above the cooktop trim. Secure back section to wall
with the appropriate fasteners (not supplied) to
anchors or wood stud. The slots in the back section
may be used to adjust spacing between cooktop trim
and backguard for a flush fit.
Attach rod etc to front section
3 Attach rod, end caps and center stanchion to front
section of backguard with #10 machine screws
supplied.
Secure front section to back section
4 Bend wedge-shaped tabs down on top of the front
section approximately 3/16” (5mm).
5 Secure front section of backguard to back section
with #8 self-tapping sheet metal screws supplied.
When mounting the front section, ensure that these
tabs engage the mating holes in the top of the rear
section.
Attach racks
6 Attach the racks to rod (racks may vary).
Finally position cooktop
7 Place the cooktop into position so that the backguard
sits flush with the top of the cooktop trim.
Follow the rest of the instructions shown in the
cooktop installation instructions.
IMPORTANT!
The back section must be securely fastened to
the wall. Failure to do so could cause damage or
personal injury if the Backguard was to pull free
from wall when racks are loaded. The maximum
weight placed on each rack should be 10lbs.
Back section
Back section
Hole
Ta b
Ta b
Hole
Front section
Racks
Front section
Rod
Center
stanchion
End
cap
End
cap
#10 machine
screws
#8
Selftapping
sheet metal
screws
Bend down
approx.
3/16” (5mm)
Use slots to
correctly position
Cooktop
Trim
Loading ...
Loading ...
Loading ...